IrkinBollikans
Well-Known Member
Found some hlg-150h-48a real cheap. Any issues running one on a single qb288?
Qb driver question
- Thread starter IrkinBollikans
- Start date
IrkinBollikans
Well-Known Member
Yes this is the 48v driver tho
Moflow
Well-Known Member
Although it's not the best fit it should work. The driver has dimming capabilities in the built in pots.
Voltage adjustment range 43v - 54v
Current adjustment range 1.92 amps - 3.2 amps
So a V2 board run at 49.86v 2.8 Amps will give you 139.6 watts at the board.
As a side note I use a mw 120h 54a driver to power Samsung F strips, nominal voltage of 48v
Voltage adjustment range 43v - 54v
Current adjustment range 1.92 amps - 3.2 amps
So a V2 board run at 49.86v 2.8 Amps will give you 139.6 watts at the board.
As a side note I use a mw 120h 54a driver to power Samsung F strips, nominal voltage of 48v
IrkinBollikans
Well-Known Member
Thank you so much for the thorough reply. Sounds like it will suit my needs just fine. Do you like your f strips? A little more affordable than boards is see
Moflow
Well-Known Member
The F Strips are a great workhorse.
Yes, I just checked. 1 x QB 288 v2 £47
2 x Samsung F strips 288 diodes £39
The QB288 V1 IS $29 though. That Is cheap, such a bargain!
IrkinBollikans
Well-Known Member
Just checked their site and saw for myself. I feel like a dummy now after cruising ebay and Amazon looking for deals. Good looking out. I think my plans for a 240w knock off have just changed. Thanks
