need some opinions on setup 1.2x1.2x2m tent (v scrog)
- Thread starter Danny88
- Start date
justugh
Well-Known Member
a scrog will get u tight hard buds ............as for the lighting it is simple u need to reflect down and in
your walls would be white or have a IR blocker/mylar on it ............your light u will need a hood/reflector to apply all the light downwards to increase the depth
your going to need a good exhaust system to remove the used/hot air .....as for your intake i would make it lower then the scroging points and add little fan that moves (st it low tilt the fan upwards so it moves side to side blowing cool unused up tho the scrog itself .....should help u avoid heat stress
click here to get a filter box idea for a powered intake ...........it will clean the air and improve the plants (they are not get mold virus or smoke dust blown on them all clean hospital grade air )
to really boost it join your local brewers club (make your own beer wine or moonshine) and apply the Co2 from the brewing to the tent to help the plants build up faster .........in the end u have beer and bud just need a cow/pig for some ribs ......life is good
Danny88
Active Member
Thanks for the reply I will be growing in a tent so am ok with the Mylar and that's how I had the intake and exhaust set up I was planning on using a vertical light so I can have a bigger screen that goes passed the light as you can see in the pic otherwise I think I would have to have a smaller screen if I used a reflector or I would have to have the light too far away btw I am using a 600w hps
justugh
Well-Known Member
vertical lights are only good for a side lighting ...........if u are 600w i can show hoods ..........
http://www.amazon.com/Goods-Indoor-Detachable-Reflector-Hydroponics/dp/B00KBAKMPC
something like that would basically be the roof of your area so the whole 600w is well used
just so u know a 600w HPS is made for a 4x4 foot print .......what u have it going in so massive overkill so u should make the exhaust system super strong too to deal with the IR heat that the makes along with the heat from the bulb itself
justugh
Well-Known Member
i would not hang vertically ..........and if u do it should be in a cool tube allow u to whisk away the heat
for u the horizontal is the best method
vert would be if u did a tressel system up the wall ...........a scrog but with u doing one on the ground ........letting the ones on the side climb up higher all good
when u trim off the useless branches or lower parts under the scrog rem to take a dab of honey and put it on the cut site to seal it off ........honey acts like a bandaid sealing off a open wound .....works on ppl too old old old old trick
Danny88
Active Member
Yes that's what I'm doing the scrog will run up the sides good tip on the honey not heard that one before never had any problems with that but defiantly worth it just in case not really thought about a cool tube yet maybe if I can't keep the heat down though
Similar threads
