stoney6283
Active Member
After a couple of test runs (and failures) I've finally got the setup fine tuned and working completely. Check out the pics below. The A/C unit is a portable 8,000 BTU. I made a duct to pipe in the cold air to the hydrohut. The duct is T'd --- 1 to the tent itself -- 1 to the intake for the air-cooled 400w HPS.
The CanFan sitting on top is connect via a T to the carbon scrubber and to the exhaust of the light. Since the light is glass enclosed, I didn't see the need to pipe that exhaust through the scrubber. I would have been too complicated.
The exhaust from the Hut is ducted to the other end of the room where it is vented out.
The ballast and other non essential electronics are outside the hut. I wanted to keep it minimal on the inside. The last thing to add is another osculating fan.
Let me know what you think.
The CanFan sitting on top is connect via a T to the carbon scrubber and to the exhaust of the light. Since the light is glass enclosed, I didn't see the need to pipe that exhaust through the scrubber. I would have been too complicated.
The exhaust from the Hut is ducted to the other end of the room where it is vented out.
The ballast and other non essential electronics are outside the hut. I wanted to keep it minimal on the inside. The last thing to add is another osculating fan.
Let me know what you think.
