How do clean your setup between runs?

RonSwanson

Active Member
Got a new setup last weekend but it was used and pretty groady; calcification and some minerals left over from nutes I'm sure.

Is there a standard plastic cleaner/solvent that won't mess up my plastic ? The gf suggested lime away but just don't know anything about it.

Thanks RIU!
 
you can use anything as long as a good rinse is applied afterwards.

i like dawn dish soap & a scrubber sponge.

then i rinse & sponge with h2o2 and water solution.

its not rocket science ...& a little calcification is like a tattoo for your tray ;-)
 
I use bleach and real hot water. I take it to the bathtub and scrub the crap out it every 3 weeks during a grow. I only use a10% mix and it works great. I scrub the tray and soak everything else, I also run the bleach water through the pump for about 5 minutes then run hot clean water for 5 minutes.
 
h202 an every 6 months or 3 runs ill soak my tray for 20 mins with a high concetration of h202 then scrub then rinse.
 
you can use anything as long as a good rinse is applied afterwards.

i like dawn dish soap & a scrubber sponge.

then i rinse & sponge with h2o2 and water solution.

its not rocket science ...& a little calcification is like a tattoo for your tray ;-)

This is how i roll super simple and easy!
 
My grow room as concrete walls & floor an the ceiling is covered with b&w plastic that make cleaning easy , First I fill up a tank-sprayer with hot water some dish soap & lot of chlorine I spray everywhere brush what need to be, Then I get in with the garden hose & rinse everything thoroughly.
 
Back
Top