Patrick00011
Active Member
This is my first time use with the EZ Clone. Only 6 cuttings, on day 13, all of them are just past the callus stage and are starting their roots. The pH is 6.0, I added no additives, except H2O2 and pH up/down. Temps run at 73 - 77, variable.
Anyways, I noticed tiny blobs of of greyish/white goo/slime stuck to a few misters. I could easily remove it from the misters. I noticed that two (2) of these "slime blobs" were floating in the res, near the pump inlet. And there was a couple attached to the inlet of the pump.
There is no slime on the ceiling of the reservoir or on the stems. Everything looks healthy.
I am hoping to finish these clones and then give it a very good wash. But we'll see what the jury says.
To people that have used the EZ Clone and have gotten the infamous 'grey slime'. Are these symptoms?
And if not, has any one seen this before?
Thank you.
Anyways, I noticed tiny blobs of of greyish/white goo/slime stuck to a few misters. I could easily remove it from the misters. I noticed that two (2) of these "slime blobs" were floating in the res, near the pump inlet. And there was a couple attached to the inlet of the pump.
There is no slime on the ceiling of the reservoir or on the stems. Everything looks healthy.
I am hoping to finish these clones and then give it a very good wash. But we'll see what the jury says.
To people that have used the EZ Clone and have gotten the infamous 'grey slime'. Are these symptoms?
And if not, has any one seen this before?
Thank you.
