EZ clone 16

Good morning fellow growers

Question on anyone who has an EZ cloner. I've done the basic directions three different cloning times. Is there any suggestions that anyone has for success with this new EZ cloner. Should i be using super thrive or anything you can think of?

Thank you in advance

I use clonex (solution not gel) and great white powder to near 100% rooting results.

Also be sure to mist the leaves daily with a spray bottle. Before roots develop the only way clones can absorb water is through the leaves.

I got the EZ clone thing down to a science. Those red mister parts that attach to the manifold can't get clogged. Using rooting powders and gels does just that so I read the directions again and it said hormones weren't necessary. And they were right. More research showed that the cuttings actually make their own hormone so the gels and powders weren't needed.
I clean out the manifold, all the red misters and the inside of the container thoroughly after each batch of clones.
When assembled I make sure the spray that comes out is fine and that all the cuttings get wet. I check for clogs every day. Sometimes you just have to give the red mister things a small twist. Sometimes they need to be replaced. I keep a hundred or so lying around. I use no superthrive, no chemical additives and I give the cuttings indirect light as they don't need as much light as they would normally. Floros worked fine for me about 3 ft from the source to the canopy.
I had more than a 99% success rate. And I had three 25 site units running all the time. Seeing roots in four days was normal and it took about ten days to root all 25.