Bho vacuum chambers
- Thread starter Ezstreet
- Start date
lusidghost
Well-Known Member
When I used to use a chamber I would sit it on a seedling heating pad with an inkbird controlling it. Plus a sleeping bag wrapped around the whole thing. It’s hard to keep a warm stable temp using them.
Cgravell23
Member
I have a vevor 2 gallon chamber with a vevor 1 stage 5 CFM pump & it works great, pulls a vac really quick and if u dont overtighten the nuts like on the gauge for the chamber it will hold the vac for days. But i was wondering if u knew anything about extracting? Cause i was wonderingvof when i put the butsne in since i didnt have the bottom valve open and allow the whole 300ml can in my 45 gram tube if my wax will come out ok?
Cgravell23
Member
Cgravell23
Member
Jjgrow420
Well-Known Member
Huh?
Use a wrench to loosen things not pliers. Looks like you've already damaged that nut on the vac hose.
Cgravell23
Member
Thats 1 1/2 days into the vac process, But since I didnt have the bottom valve open when I stuck my first half tube of tane in? Does it matter that after about five minutes i let off that bit of tane out of the tube and then put another half can of 300 ml tane in with the bottom valve open, and then closed it and let it set for about thirty minutes, then let the tane off & let it set a minute & then let more of the tane off then i ran about another half can of tane through it the last time, to flush the rest if trychs out. Did i not let it fully saturate in enough tane @ first by not having the bottom valve open for the first minute or two?
Jjgrow420
Well-Known Member
1.5 days ? It should be flat. Im not sure what you're talking about really man. What valve? There's a million diff tubes people use. I run straight through. No valves. Glass tubes.
Your oil doesn't look right
How hot is it?
Cgravell23
Member
It was some low qaulity stuff ig, may have been grown outdoor too idk, i bought a lb of it for $750 said it was mids.
Cgravell23
Member
On a closed column/ open loop.
Jjgrow420
Well-Known Member
I see. Just remember you can't make gold from iron. If it's crap going in it's crap comming out too.
I'm not sure what you did man. Shouldnt be bubbling like that after almost 2 days. I'm thinking it's too hot.
Cgravell23
Member
About 78/80•
Jjgrow420
Well-Known Member
I don't fuss with valves and shit man. Run straight through. The longer a solvent sits in something the more unwanted shit it's pulling out. 'quick wash' right into my ptfe paper.
Once it's done it's major bubbles into the vac. Keep pulling vac and dropping the muffin until it's stable then full vac and let purge for 24ish hrs flip and revac let sit for another 24 hrs and voila
never go above 90°
Cgravell23
Member
Jjgrow420
Well-Known Member
You can't temp gun through the glass. It's not accurate
Cgravell23
Member
Cgravell23
Member
Yea, i know. Lol idk y i did that