Search results

Thank you for the inputs. I ordered the parts, had a good convo with ChatGPT it only cost me 10£ in material. yes I do know there are light controllers and they are next level when it comes to led fixtures. my device would be an attachment for the knob on your actual old school ballast. So...

Hi guys, I want to make an arduino based device that flicks my ballast intensity up or down depending on the temperature reading. the device would also control “sunrise” and “sunset” (not as precisely as an led led controllers but using the increments on the ballast, set time interval on each...

Hi all, just for curiosity, I have looked around and some of the led lights can be connected with controllers that checks temperature and if it goes too high the controller dims the fixture down. There are some light fixtures that can be connected with a normal digital ballast. These fixtures...

Yes that looks decent, just watched a few vids about it. I really like their light controller (does it come with it or it’s a separate purchase?) I was looking at very similar ones but uk based. how was your results? In terms of quality. what would you say, how deep is the properly penetrated...

Just for reference, these are the lights I had a Quick Look at. They all look the same to me (more or less) any opinion? Or anything similar with proven better quality result?

Hey thanks, to be honest I’m not sold on this one. The videos are 7-8years old, I’m sure there was improvement on led light since. I’m not after weight, but quality. They might have cropped over a box but I doubt the quality was top notch. Have you used this light yourself? Have you got any...

Hi guys, it’s been a while but I’m planning to have a few runs in near future. I used to use hps and small cob lights before. I want a led fixture for a 5x5 area. can you please suggest? Please, I’m not looking for the cheapest option, I want a led that penetrates well and produces nice...

Hi, I’m planning to make gummies and I have no clue how many mg per gummy I should calculate for. can you share your thoughts? what would be a mild normal and strong gummy? Thank you

Hi everyone, my question is not what the title is. I do believe you have to do the decarb before you start simmering the butter. But, my question is and I can’t really find any info about this. So when you decarbed the flowers, you cooked it for hours on low temperature (90c <- am I right on...

When I was in college, I met with a metal band who made their room soundproof with the empty egg holders... that’s the cheapest version, but you can also buy it. The foam is much more efficient :)))

You need to get a variac. It works with a different method to decrease your fan speed. No buzzing noise at all.

Hi guys, Here are 3 of my critical cheese auto. They are crowded, and I’m getting too high rh during their 4 hours daily break. I removed a few leaves, as they are auto strains, would you defoliate them more?? If I leave them like this, can I get bud rot if my tent rh is about 65-70% during...

Get an aircooled hood for that 600W hps or dimm it down.

Hi guys, it’s been a while, I almost finished my first bubblephonics grow. This lovely gorilla glue auto from fastbuds performed well. I was talking about her weirdness, I don’t know much, but I never seen plant going into 2 direction on it’s own, this little one did it 4 times on her lifecycle...

How close you keep the lights?

turn the light and keep it way closer, buy a cheap reflector. buy the hid light with option to use it with MH and HPS bulb... than you will get the more blue for veg and when you change to hps more red for flower. check a comparison between cfl and hid lights...

Hi Guys, I'm just googling about DO levels in water for my next setup. I cannot really find a good article about flooming. at the moment im using airstones (first time), they are a bit noisy and they do a good job but im not sure if they are the most efficient DO level maintainers. Can...

dont change water for the first 3-4 weeks, then change it every 7-10 days. lift it up (put it on something) and put a little drainer to the bottom. get another tank, connect it with the one you have on a 1/4" tube, buy a float valve. It will keep your water always topped up. 2 of this (1 for...

Hi, it’s me again and I’m kinda excited how she will finish. She got a little extra calmag yesterday. Hopefully those brown spots won’t appear anywhere else.

:lol:Hey, just a little update. I’m not really sure but it seems like that this little cheeky one just simply “topped” herself on its own. :D