Search results

don't post your fake experience in my fake thread....

3650k produces the highest quality

Lolz I cannot believe this fake thread is still going

That is great to see....figured it was more marketing fluff :)

Let me guess...next friday

How much longer till Samsung's logo is on your board? Its been several months.

Based in China, giorgio11185 has been an eBay member since Aug 07, 2002 giorgio11185 (185455) 99.8% positive feedback

Curious to read the results of unrooted cutting going 12/12

assuming you don't engineer.... you are correct that a "metal" flat washer and a "metal" lock washer are electrically conductive, all be there are nylon alternates they are not needed. so assuming a "metal" flat washer (with rounded edge, nothing to cut surface) and a "metal" lock washer...

Arduino's are cheap.... https://www.arduino.cc/en/Tutorial/PWMhttps://www.arduino.cc/en/Tutorial/PWM

Form Factor

same...poor assembly practice...a dot of blue on the threads..no retighten

Fortunate enough, never had to deal assembled boards, always was on the surface mount side at the component level. When I was younger I spent many a fun days with a micrometer and calipers, opening boxes from china and ensuring the board mount pcmcia slots were to a networking companies specs.

Aka did you spec the aluminum for the board? if not, great its softer than other stuff you have worked with....again what is your point? For your form factor board....strip users can use thermal tape :bigjoint:

Rakin show's good math skills in other posts...

1: If you use a thermal paste you would not have needed to tighten it as much to make sure you have contact between your board and your heat sink...Unless you are surface polishing your heat sink via granite and the same goes for your light panel, you will have poor thermal transfer. 2: Why...

R2T = Run To Target....vendor on alibaba

You asked for it with a question like that.....you are the type of consumer companies love....hence the led HPS bulb replacement.... both combo's run the power supply at max, the lumen output will be more or less same if you run them through the calculator, one will have a more efficient lumen...

No, I am not...I read it on the internet.