Search results

Yes, Used it my last grow and my friend has uaed it her last 3 grows. Neither of us will "bloom" without it. Makes that much difference. Follow the directions exactly and decrease your usual bloom food by 1/2. It is that powerful. GL HH

Thanks guys for the replies. Obviously there is quite a lot of agreement. Actually I would call the folks who did this "mentors" as this is my first solo grow and they have helped me alot in some ways. Thanks again. HH

Believe it or not these are friends (?), not only that, they're growers. Hence the question that initiated this thread. Thanks for replying, I take it you agree with me. HH :hump:

Tell me please, your thoughts on people visiting your grow who feel compelled or even necessary to touch your buds. I think squeezing can set buds up for, if not cause, rot due to bruising deep in the bud no matter how gentle someone "thinks" they are doing it. This makes ME CRAZY, and I fell...

I have been fighting what appears to be total nute lockout for about three weeks. The clones were initially healthy until transplanted into hydroponic room. The initial ppm's for nutes were 400, pH corrected from 7.2 to 5.6-5.8. Watering with Multipure under sink filtration unit. Within...

Please give details. Soil?? Watering freq.?? Need much more info please. GL HH

Roflao.........

Sounds really good to replace MH bulbs for vegging. I'm not so sure about sodium however, since they have a better spectrum for flowering. GL HH

Yes, But I had some diff. finding them when looking. Sorry I don't remember any names. GL HH

Humboldt Hydro sells 2 diff. ones from Intelli Drive 6 & 10 rpms. The 6 moves slower than the ten, about 7 1/2-8 1/2 min. per cycle to go 9 ft, the 10 about 5 1/2 to 6 1/2 min per cycle for 9 ft. however both have up to 60 sec delays at the stop points to even up the overall time spent over the...

Great idea!! I was wanting to do one on this grow. I took the plunge and ordered some seeds from GB so as long as the gov doesn't knock on my greenhouse count me in. Thanks again for the great opportunity. GLTA HH

Give them some time. Are they the same distance from the hps that they were when under your other light? If so dehyd is prob the problem, worse case would be burn. Put your hand under the light just above the top of the plant, if it gets too hot after a minute or so, that's your prob. GL HH

That clawingis usually caused by overfeeding. Without more info on what your're feeding, lights, etc. I can't be sure. They won't straighten, but they'll work normally for the plant, so I wouldn't remove unless their yellowing. Sounds like it's resolving but I'd flush them well stop feeding...

You really should separate them asap. I would get the plants and soil into a large bucket of water and gently attempt to tease the roots apart. Go slow and try not to tear. Do this while the entire root ball is in the water. If you have to cut them, give each plant as much root mass as...

Need a ton mor info esp. on your lights. Until then couldn't even hazard a guess. GL HH

Fox Farm has directions printed on the lable. Most folks will start out at 1/2 strength the first couple of feedings and then go up from there to full strength. Don't overfeed it stresses the plant. GL HH

Go to hydro store. Buy bloom food. Follow directions printed on lable. GL HH

Probably got too dry at some point. The leaves are large and heavy and the leaf stem may not have been able to totally recover. Your plants are great and obviously the problem was way in the past. I have had this happen before some recovered completely (with leaves up) and some stayed down...

Was there a pH prob that made you need to correct with vinager?? How much vinager? What's the pH now?? I'm thinking you may have your soil too acidic, and the plants may be having difficulty uptaking the nutes. If you can't check the pH I'd run about 10 gal. (yes ten, 'cause your pots are 4...

Just finished your beautifully done journal from start to finish. Congrats!!! You've convinced me to start one as well. I can't wait for the final weight as well as your report on the smoke. Thanks for all your work putting this together, as well as your kindness and generosity in sharing...