Search results

I already built one, i wanted the trellis to mount to the outside corners of a 4X4 botanicare tray, so i really just need the clips.

I am looking for a place to buy this trellis can you help me?

Are you saying my setup sucks then? I wondered about the stretching factor. Maybe it's to early to tell but i am on day 9 of flowering and so far i don't see any stretching. only time will tell.

I am using one, just started using it 9 days ago, so far i love it. It's a light rail 5 and i have two 400 watt lights on it

I bought the tri-meter, so far i am impressed.

Maybe a little H2O2 might help

Sounds like your room temp might be a little low

I bought a RO200 4 stage system and my ppm is running in between 3 and 5 ppm, after new filters you let the holding tank fill up one time, then you drain and toss the water, after that everything is good, no waiting time involved. It takes 3 1/2 to 4 hours for about 3 gallons of water.

so the consensus is there is really no reason behind it other then reducing it's size

i don't understand the top off water part i was considering purchasing one because you can just leave the electrodes in the res. I am assuming that every time you want to check your res, you have to put the electrodes in there, like a hand held.

yes, but it dries in 12 to 16 hours without being pressed, what i have read it says to heat the press with a blow dryer while pressing the hash?

Why is hash pressed? I have seen hash presses that use a hydraulic jack system to press the stuff.

Here's the best i can do for a picture.

The trichomes is what i will refer to them as, on the leafs surface ( To avoid any confusion, i realize the trichomes with the heads on them are also on the leafs surface, which i can see clearly ) However the ones below the trichomes with heads on them are actually to small to see a pronounced...

No am i not looking at pistols, wish i could get a pic, but that's not possible, Is it possible that the trichomes are cloudy but the surface below is just the leafs texture? at any rate below the the trichomes everything is amber

I have read that co2 is not used during the flowering cycle, only in veg. The reason i bring it up is because it does not make sense to me to not use it during flowering.

No when looking at the trichomes, there is much smaller particles if you will that are on the leafs surface below the trichomes, unless that's all trichomes and i am not sure what i am looking at, maybe we could call them crystals?

The trichomes are cloudy, i am on day 63 of flower, ebb and flow + 600 watt light. When i look at the trichomes through my little scope (Radio Shack) the smaller particles that lay below the trichomes (if that makes any sense to you) are all amber, I am looking for a non-couchlock high is it ok...

About how often do you need to replace the electrodes?

What's the average time you flower you White Rhino?