Search results

I'm thinking so but I'm a rookie so..... ;-)

ok, just switched to the week 6 and beyond nutes! SS!, noticed no GW/pondzyme listed. Not needed from here on out?

Ok, did measured again and then noticed something flashing. Had to have my son look cause my old eyes couldn't tell what it was. Apparently my meter only has 3 digits and the flashing was x10.... :wall: Good, just been looking at everyone else's pics and I'm like, damn, mine are little...

Ok, I'm just finishing up week 5 on flower. Plants seem to be a little small for this long. Been paying attention to my PH and keeping it to what SS1 recommends for each nute batch. I haven't been paying attention to the PPM but tonight I check it and it's at 155 which seems really low. They...

well, maybe that's the problem then. Most have had a few decent leave on em. I'll trim from here on out and see if that makes a difference.

Does the amount of fan leaves on the cutting make a difference? More or less better or no difference?

I don't see that a turboklone is must different than the SB cloner. Especially when I have a chiller on the res.

Yep SS1. Following your setup on everything (nutes, ratios, etc)with 80sec on 8min off.

Always from vegging plants but let me ask this. How much should you let them develop roots before putting in veg?

Using the SB cloner and it's been taking about 3 weeks. Do different strains take longer?

Wasn't meaning the sprayers. I was asking about going from the barb type connectors that come with the pump( and the associated hose) to PVC

Ok, one thing I don't get is how you guys are going from the irragation type of connectors I'm seeing in pics to PVC?

Ok, sounds like you have an enclosed loop there and you weren't running your nute water actually through the chiller

So you still had totes that the rails were draining into, correct? And just gravity feed back to the main res?

Found a great deal(craiglist) on a 1/4 and 1/2 hp chiller. I've got the 1/4 setup and it's working fine on the veg system. Veg totes on a table with drains back to res and the chiller cooling the res. My problem is my flower setup. I've got 2 three rail setups but I've only got one chiller...

Ok, new question. I bought a couple chillers to help with my res temps but not sure how I should connect them as they need pumps. Should I use the pump that supplies the sprayers or get an additional pump(s)?

So then you do similar to what dimebong did with the dehumidifier?

Care to elaborate?

First time grower running a SB/SS1 aeroponics system and my water temps are creeping up. So, I'm a bit confused as to what I need for a chiller. I've seen wort chillers, homemades, Active Aqua, etc, etc. Just looking for recommendations before I go make/buy something. Thanks.

We? You have a mouse in your pocket?