Search results

Another month should do

this reader is going to measure ppm for all of you. Get me my cup.

How many ppm is pure pee? Assuming satisfactory hydration. Will it burn? Not does it burn

I was going to show mine but… those are pretty big. Hard to beat. This ‘summer’ hasn’t even been 20c yet. It’s so cold and windy garden suffering.

Take it out of the bag. Put in another bag, with a moistened paper towel that is not touching the stuff. Let it sit for a bit. Then put back in the grove bag and see the humidity.

Maybe the herb is absorbing all the moister from the pack? How long has it been. Maybe it will equalize

Chop that one. Then think about the others

Wind or heat stress. No big deal. The plant looks good other than the leaves curling. How hot is it in there. Fan blowing directly at it? Hot light too close ?

I always have the same problem, things just get yellower and paler. I might try a drop of ph Up. Is there a harm to water ping a little higher pH in soil? I have purple stems, phosphorus low? Well at low pH it becomes unavailable. Maybe I have lots of mutes I’m just locked out. Ya I’m going...

Master grower responders only! if you was to graft the stem of a flowering stem onto a vegetative growth root ball, how would the states work out? What week is the optimal week of flowers to do the transfer? Imagine a vigorously growing huge fresh rootball. Where do the hormones change? The...

So you ph upped some water? What was the fix ?

Just trim some leaves with scissors

The problem could be that mold grows where the water is.

That’s the transpiration of the leaves. Emitting water out the leaves. If they are touching others the water can rest there and cause problems. That’s why u need a fan blowing them. And that’s why you want to keep your leaves clean.

Too much nitrogen, revegging? Bad genetics? Cut a nug off and wait 2 weeks to dry it. Then smoke it and then see. Are you going to flush to try and get some fade ?

Spread the branches down and tie. Cut off a lot down below. Fill out the 3x3 How many inches or bud sites can an LED penetrate ? Maybe 6-8 inches? Everything below that is _________

Yes they will be fine. Give them a break.

I never use a bag. I would also like a bag less mold that you can really fill up. Have little holes at the bottom. Have the heat things be drilled into the mold. The press won’t have plates. It will have the mold. Hire me Dabpress.

But is this better or worse than political threads?

All those tall tops, bend them under the screen now or they will reach to high. That’s the point of the mesh. Fill all the empty spaces. You want it to be flat now.