your propbably on the right track with cal/mag. really probably not breathing well. i would stop tucking and trim the undercarriage quite a bit. flip it and feed it. watch for mold and move air around it.
I have a blue lab ph meter and I really liked it. I stopped using it for a while, stored it like I normally would wet bulb. Now it reads around 1 ph higher then it use to. Ordered new calibration solution to see if maybe I have contaminated my current solution.
Was wondering what anyone with...
Pull all your water out change with 0 ppm ro water see if they straighten up if not they look like they done for. also make sure to mix macro and micro in correct orders and rest between macros 5 minutes to let stabilize. looks like a bad resi change which caused lockout but what do I know I...
Well in 120v it's function is a return path for current (amps) in a 240v it doesn't serve that purpose if the two hots balance each other out (equal loads), it's sole purpose would be to handle short circuit loads. this is why ground and neutral get bonded at one point for worst case scenario...
I see it says you pulled a permit, but that wiring does not look to code unless all loads have no neutrals. knowing what is going on here that is not the case. next time go with a extra wire so the 240v circuits have a neutral. long story short, neutrals blow breakers, not the grounds. by...
I feel the same way when I sustain from smoking, it passes in a few weeks time. There is a root issue that isn't resolved that multiplies the feeling of depression. see a doctor, try an alternative route to happiness