with the 2 reds in parallel they should each get half of the ~ 0.8 amp and the ~24 v strip the full ~ 0.800 amp, was my understanding. if thats the case then in reality the 33v would prob draw a bit less and the 24v would be pretty close to 24v, kind of running the whites hard and the reds soft...
can anyone confirm this wiring for me?
the driver in question is lne-54v-185waa
the red strips are
SSK-1560-EMP-660 (33v or slightly less with this config, i think)
yellow are h series 2ft 4k strips (about 24v maybe a bit less.
orange are 2 yellows in series, not in question.
also...
Well I went ahead and bent a few stems the day I was suggested, thanks again.
In retrospect I should've gone lower.
Anyhow here's a pic of after the bend and now.
Hope it helps some other newbs in some way :)
Thanks. This one is in 10g ish soil. Killed her brother in the same container. It's cool to pinch and bend/ snap these at this point? I suppose leaving as is would be a negative.
Heyo. Still a newb. I knew I had to flip soon or they'd get too tall, but It appears I was too late.
Can I break the stems safely?
Should I leave them to grow in to the dark?