i topped every new node on one plant i had just to see what happened. wasn't a very desirable effect though. plants branches just became thin and fell over
I bought an iphone 4 and it has location services that some apps require to be turned on.
it also remembers the Coordinates of photos i take and maps them on google maps.. it can be turned off, but if need be. i'm sure law enforcement can bypass it?
Whats the temperature and humidity in your room? and how close is the light? and how have your watering cycles been?
EDIT: Both 3 gallon plants are doing awesome, but both 1 gallon plants are curling? Possibly root-bound?
I prefer MG, i've not had a single problem ever..
just near harvest i put a lot of holes in the bottom of the pot and let the water flow through until i get no nutrients in the used water.
then the MG isnt so hot anymore.
It is a good deal.
FYI you need to forget about those wire nuts they give you.
Soldering is the only way to go. and after you solder use heat shrinks to seal the wires.
And it definitely needs to have a grounded enclosure. but all this can be done at little costs.
Sunlight losses 50% of it's brightness and intensity after a 12 inch separation between the top of plants and lamp.
So either way those bottom branches don't really soak up too much sun. but your headed in the right direction.. bending and twisting the stems to fit CFL's in between the branches...
In my thread I ill post update pics on it.
It decided to change Phyllotaxy on the 3rd stage leaves.
It's growing alternating 180 degree pattern again after 3 sets of Whorled Phyllotaxy pattern leaves
>Thread>>>...