Recent content by SleepWaka

do you think leaving it at 110 degrees will be fine or should I lower the temp before leaving it sit for 24 hours? thanks for the help :)

I don't have a vacuum only a hot plate, so I'll be making due with that. Here's a pic I took about 15 mins ago should I wait until the bubbles are completely gone then scrape it up? Or should I scrape it up now, toss it on my oil pad and then back into the dish to bubble more

So I'm working on the second batch right now, I emptied the tube and hand busted it to small bits, packed it into the tube nice and tight. Even though I had packed it completely the first time, this time there was about an inch of space between the material and the end of the tube. I heard...

Here's a pic of the first run nice wax no sizzle. Not very flavorful though. I'll have to lower the heat next time. Still waiting to do the next run. For the second run how can I try to get shatter rather than wax? Reading around I read lower heat w/ heat gun to pop bubbles will heighten...

Thanks for the suggestions everybody, I'll be doing the second run tonight. I'll make sure to grind up the material and pack it tight while still leaving room for airflow. I will report back :) cheers

Hello, I know this question probably comes up a lot but I was hoping I could get some insight into what I might have done wrong with my method. I started off with ~38g of purple kush, pulling the large buds apart into small buds, but not trying to ruin the integrity of the buds. I stuffed my...