Recent content by sk8punk318

It all has to do with genetics, and stress. Stress can cause extra random leaf growth, and misshaped leaves. In this case I would have to go with genetics considering you didn't say you stressed it at all, and the odds of stress causing this is such a small chance. It could be a recessive trait...

Your fine. Unless something involving botrytis happens and it spreads through ur clone or seedling you should be ok. You can FIM or top after a couple nodes, but thats not recommended. Good luck!

If you did pull it off and the plant did not suffer enough stress to kill it or bacteria didn't kill it you should be fine putting it into veg state. Just leave it in 24hour light until you start to see new leaf growth and not calyx production. It will take weeks for this to happen because the...

The HPS mimics the change of spectrum that the sun gives off as you enter fall. Don't use a MH during flowering that doesn't make sense. Your looking for bud growth, not leaf growth. If you want you can use a full spectrum and that will work better. Go with nature man and switch that shit to HPS.

base your distances as if u were treating it as a vert. setup and also the hand test works as well for heat. You also have to put into consideration that ur plants are gonna get a lot bigger towards the end of flower so focus more on flowering than veg growth because in the end u don't wanna...

base your distances as if u were treating it as a vert. setup and also the hand test works as well for heat. You also have to put into consideration that ur plants are gonna get a lot bigger towards the end of flower so focus more on flowering than veg growth because in the end u don't wanna...

I've never done it before for the fact that it's more work for the same amount of yield as a flat if u took the vert. system out. It's just a small Colosseum and now you have a bunch of plants to worry about instead of just a handfull (Depending on size of grow space). it's not really a time...

Don't try and clone an auto flower thats just a waste of time. They AUTO FLOWER so there gonna be worried about budding more than they are growing roots. Your better off getting seeds from one of the auto flowers, and keep doin it that way.

It really depends on how you handle your plants during the transplant if it were to effect your bud growth. If you have to transfer to a different pot it would be best to use the same soil unless the soil ur using right now is not doin the job. Don't really worry to much about pruning roots...

DON'T USE MG! It's a universal plant based medium, but that doesn't mean that ur cannabis plants are going to like it. Go get some FF soil such as light warrior or happy frog. You will be better off.

Ok your not gonna get a lb. from each plant i'll let you know that right now. Especially if your gonna use LED's because yeah I guess they are the future some what, but they don't cover as much area as a HPS would nor do they have the lumen output like an HID does. Yes I know about the less...

just gonna have to let ur water sit for 24 hours or get some distilled water

didn't see ur posting about it, but yeah were both on the same page on it. DON'T USE IT! fish like it though...

I own some fish so I have some water treatment by API and basically what it says is that it breaks the chloronic bond getting rid of chlorine and hard metals. I have been using it for a while now adding 1 drop per 1 gallon of water, and the results have been so so. I haven't really seen a...

nitrogen for sure, it always starts at the bottom and works its way up. the yellow leaves won't turn back to green and eventually they will fall off. base ur nutrient intake from the taller leaves