Hey guys.
First timer here. Me and my mate got this setup going and about a month ago we ran into some heat problems. After the help from this lovely community we overcame it and were happily cruising in our 4th week(22days) of flower until........
We have yellowing on 1 out of our 4 ladies...
I have just switched the exhaust and filter to the tent ceiling and the intake at the bottom. We have the exhaust venting into a grill on the wall which is sealed with duct tape so it is getting blown out of the room. I just opened the vent flaps around the base of the tent to see if that helps...
Yes they bow, like they are getting sucked in.
The in take is coming straight from outside. We now have a 6" fan pulling air. Only lowered the temp a few degrees.
We dont have the cool tubes yet and are trying to sort this out before buying them. Gonna change the exhaust to cieling and intake...
Lights are off now and the temps are at 27 cel and 83-84 faren with the lights off. Same as todays outdoors temp. All our readings are from a shaded area.
How much of a difference will it make if we swap the intake to ground level and exhaust up high...? My mate is worried about hanging the...
Ok, so we are have I am presuming heat issues.
We have 3(origiannly 4) hps lights for our 4 plants. Turned one off because of the heat issues. We have a 10" exhaust on the floor exhausting straight up out of the tent. The intake is a 6" fan pulling air from a slot in our boarded up window...
First image is just a 6" intake with no fan. 2nd is the lights and 3rd is the base of tent.
The filter and exhaust in the back corner goes straight up and out from the top.
Those 4 600's are just way too hot atm so we dropped back to 3.
My mate suggested having another 6" intake running from...
They are all in a row. So you mean have the 10x6x10 tee along one side of the hoods and cap at the end of that side.
What about the exhaust on the exit of the tubes? Connect with tee's again and just exhaust from a 10" just like the beginning?
So should I start at my filter/fan then straight to the cool tubes and zig zag through like an S then straight out the tent all in one stretch of duct? Thats with the reducers? Its a single row by the way.
Should I expand back to 10" before I exit the tent or just leave it at 6?
Also will this...
Running 4 600w hps lights in my tent just with regular reflectors but am getting high temps. Got a 10 inch exhaust fan pulling the air our but if I have 10" duct how do I incorporate 6" cool tubes into my setup?
Do I use an adapter and have the air pulling through the filter, exhaust fan, duct...