How are you accounting for current vs. voltage curves, did you digitize them? I mean you specify a target current are you pulling the voltage value of the documented curve, or just using min/max values?
Reverse Osmosis. They sell systems all over the inter tubes. It’s a series of filters that get your end water down to almost 0 ppm (mine got it down to 20, off well water).
You know I started recalibrating every 2 weeks in the beginning, but found it wasn’t necessary because it was spot on. Maybe it was my environment. Definitely checked it at the beginning of each run, both veg and flower. Doesn’t hurt to check more often than less.
You are correct, but in my experience if your main line is large enough and you have enough flow, it should be minimal. As long as GPM out < GPM in, he should be fine.
Another thing you can do is create a loop, vs. single feed line. This effectively doubles the diameter of your pipe by feeding from both ends (given your main line is of sufficient size ). This helps equalize pressure so the guy at the end isn’t getting just a trickle. Put a T and valve at the...
I had 2 separate systems: 1 for veg, 1 for flower. The chiller set next to the resivour and had the system water/nutes continually pumped through it. I had a valve to adjust the amount of feedback flow through the chiller. Was able to keep a 16 5gal bucket system at a constant 68 degrees! Of...