Yeah that's what was odd the mother was never in flower and while these clones were in veg they just started shooting out weird leaves like 4 weeks in until that point they were completely normal
Yeah that's all that was different that's pretty much what I was figuring just wanted some input and to share so other people can learn thx for the input I will keep updating until they finish
Yeah they're12/12 I'm using Elite nutes no light leaks The humidity went up a little as did the temp but I'm pulling air out of the room and have indirect fans so it's not bad I put a dehumid in the other day. The first grow they were fine everything was normal this time I had to keep them in...
I got them as clones made a mother and the first batch came out fine then this time I had the leaf mutations in veg and when I turned them over they kicked out of it and started putting out normal leaves and everything looked fine now the last few days this. Those little pods at the bottom...
So these GG4 are a little over 3 weeks in. They were acting a little weird in veg putting out single and 3 finger leaves but they were healthy so I kicked them over. Now they are not looking normal. Usually at this point I normally have nice white fluffy balls. I don't have a clue what's going...
That's very cool. Is it an h2o pump he's using in the res and then it just pulls the O2 in with the T and the tubing? I will be building a few of these. Thanks.
They beautiful brother. I will most likely start transitioning to those stones. I get great results with the clay but like I said they just constantly erode and leave crap in my tables/res. Thanks for the input.
That's exactly what I do load them into a tub with a little bleach soak them for a couple of days then throw them into this big thing I found that's like a laundry basket with smaller slits and just rinse them. They just end up rolling around on my floor when they spill, It's not a big deal at...
Yeah the floating around can be a pain because of course they can float out and cause problems. The pots I'm using are probably 6-8 inches so when I fill to 4 inches I'm good so yeah just adjust and compromise to your situation. There was another reply on here where the cat said he's using...
I don't use plastic to cover my tables it's a piece of half inch insulation that has a semi reflective sort of foil casing on it and I've just cut holes into it that I set the pots into, so it doesn't hold in quite as much moisture as the plastic. As far as protecting the pumps, as long as you...