Recent content by Mr.Flint

Old school? Do you mean like with rockwool or a bubbler? I have the materials for a bubbler.

I checked the water while I was in there it's not warm at all. I have a dome somewhere I'll put on. I'm just having trouble understanding why so suddenly I'm having trouble cloning. Previously I had almost a 100% success rate and now I can't get anything to root.

The cloner is sitting in a grow tent which is on a few pieces of old carpet. The lights are about a foot and a half away. I was running the lights 24/7 which is what I've always done in the past but today I switched it to 18/6.

Here are photos taken today. You can see the browning where I made the cut and the leaves browning as well. One of the cutting has the beginnings of roots but it's been like that for about two weeks now with no further growth.

In my previous runs I never had a dedicated mother plant, I run a perpetual harvest setup. I always just took cuttings from the plants in veg. I ran it like this for over a year with no problems. I started a new plant from seeds and I've been trying to clone from that with no results so I know...

I'm thinking about adding an airstone and an air pump to the reservoir to make sure the water stays oxygenated.

In between clonings I always clean the cloner with bleach-free clorox wipes, I clean the surface I'm working on with the same wipes and use a clean razor blade every time.

I don't know if there's necessarily anything wrong with my water, but it's the only thing that changed between when I was having 100% success to 0% success. I have a bottle of h2o2 meant for growing, yesterday I added a little to the reservoir because I've read it adds oxygen to the water. I...

A little bit more info. The pump is set on a specialty timer so that it runs for 1 minute every 5 minutes. What I'm seeing with the cuttings is that they perk up toward the light like they've always done but over time they just wither and die. The bottom part which gets sprayed starts to turn...

I'm having a problem getting cuttings to root lately. I use an aeroponic cloner exactly like the one in the attachment, I've been using it for over a year with no problems, I previously had almost a 100% success rate. However these past few months I'm hard pressed to get anything to root. At...