Recent content by maya101

Hi there, Today I went to court charged with production of cannabis. When the police raided my house there were no plants, only sophisticated growing equipment and the harvest from the day before, so the cannabis hadn't been dried. In the police evidence report, they state that the cannabis was...

Yes, extra crispy chicken. I've been feeding Hesi nutes: Hesi hydro bloom 5ml/ltr; Hesi Powerzyme 2ml/ltr; Hesi PK 0.25ml/ltr in week 4, increasing the PK each week. I think *BUDS is right about the heat/light burn, I don't think it's nute burn.

OK thanks, I've raised the lights as no doubt you're right. They were about 50cm above the plants, but I thought that would be OK given that I use air cooled reflectors. It does make sense though as the symptoms are most pronounced in the tallest plants. Thank you!

Ok thanks for the info, I shall keep a sharp eye out for the balls... and a sharp knife.

Hi there, On one of my plants I have found a single male flower, on the lowest branch. I haven't seen any other pollen sacks on it at all. Is it possible that hermaphroditism can be a localized thing, or is it a change in the whole plant (i.e. if you see one male flower, more will definitely...

Thanks for the reply, But if it's nute burn why would it be most pronounced on the plants with the biggest buds? Could it be that the bigger plants have more root mass, so are taking up too much nutes? Unlikely, as I would have thought it's to do with the concentration of the solution. I use...

Hello all you fellow growers! Firstly, I would like to thank all who post here. There's more practical knowledge on this (and others) forum than can be found in any book, so thank you for sharing it. I am currently growing two strains: Chronic and Bullshark. they are flowered on separate NFT...

P.S. Do you run your pump on constant, or at intervals (i.e. 15 on 45 off)? Thanks again!

Hi NFTfan, That sounds like an excellent idea! I was thinking of putting them on a cage in the heated propagator tray, but pebbles sounds like a much better idea.

I should note that the clone box is the only place where watering is not automated, so it has been kind of hit and miss with keeping the moisture levels correct in there

Hi there, I have a setup with a 2.2m x 1.3m flowering room with 4 x 1.2m x 0.5m NFT trays, a 1.2m x 0.8m mother plant room with 4 autopots, and a small clone box. In the flowering room I have 2 x 600W HPS air-cooled lights on 12-12. The mother plant room has 1 x 250W MH on 24/7 (I think I may...