There are so many way the POCO can find out if your stealing electricity. This is the most accurate way. Each transformer has a meter and is on a grid system. Each meter sends back the info back to the POCO for usage. The way they detect leakage is when the math does not add up between meters. I...
Update - Bottom fan leaves have all turned yellow. I was flushing for 3 days straight. New growth very green. I have adjust PH to 5.8 today and starting to up EC to 1.8 today starting at 0.4 EC. Plants are still drooping. Slowed down watering. STill Lost !!
Update - Bottom fan leaves have all turned yellow. I was flushing for 3 days straight. New growth very green. I have adjust PH to 5.8 today and starting to up EC to 1.8 today starting at 0.4 EC. Plants are still drooping. Slowed down watering. STill Lost !!
PH meter is very accurate. I calibrate every time before I use it with 7.0 solution. I usually check ph , then mix the nutes stir then check PH and then adjust PH to 6.0 then add boosters.
I am in Los Angeles, so hard or soft water I'm not to sure. I do use TAP but let it sit for about 3 days before using it. EC is around 0.4 when I use it. Since my EC starts at 0.4 and my EC is 1.2 wouldn't my EC only be 0.8 and would that still be strong for Nutrient strength?
Every single plant is starting to show signs of burn. The bottom fan leaves are turning yellow already. New growth looks fine, nice and green. When you say split, what do you mean?
Next week I am going to be filling the flood table with hydroton. I was hoping that by lowering the nutrients I could put less stress on the plants due to the fact that I have to much heat. thanks for the advice. I am currently flushing right now , do you think I should continue or stop flushing?
Thanks for the advice. Getting more ventilation is a little harder said than done, due to the setup. Long story. I know air flow is basically 30% of growing, but the first 2 weeks of veg they were doing good. Usually ppm/ec should raise weekly to reach max potential, should I lower ppm/ec to...
I am having multiple problems on my plants, but they seem to contradict each other. Some signs of overwatering seen, nutrient burn and low nutrients. I know, it is confusing. Please help. Here are some questions about my setup and what I am using.
1. 2 - 400w MH Bulbs - 6 Plants
2...
I was currently feeding 3x's a day 4 x 4 tray - 290gph pump, 35gallond reservoir for 12 mins with pump on and drain. The thing that is confusing me is that hydroton should be watered more often than that. I have heard some people watering every 3 hours with hydroton at 15 min intervals. I am at...