Recent content by klara niema

hey, I went the same way as you just cut off until 4mm so it would fit nice and didn't make a rim i've posted some pictures on the stinkbud forum thanks for this :p I know you use pure nft, are there any advantages using the spraysetup or do u think the nft way gives the exact same effect? is...

stinkbud i have a question i'm making a system but ive noticed that the caps are not watertight i could silicone them but since i work a little different and have a drain under the fencepost i should have to silicone both ends and i won't be able to remove my spraybar to change sprayers anymore...

heya, I was looking to do the same as you in keeping the res outside my tent. I thought about a uniseal/bulkheadbut this will keep some water in the end of the rail since it's a bit higher than the pipe is that's bad or not? i saw you used a threaded coupler with cut holes in the sides did you...

Hi, i made a post in one of your posts i still would like the schematic if possible :p but i wanted to ask something related I was thinking about using a 100k digital potmeter that is controllable via my arduino is this a bad way? do u have more control via the other method? thanks btw

hey in the intro you were talking about the 0-10v dimming of the hlg drivers from the arduino do u have a schematic how to do this? the programming of arduinos is nog problem always those dem eletronics that are needed :p

hey, i'm atm trying to get the dimming part working from my arduino but the schemes that SD is giving aren't working i saw you made a post in dec on the forum , did you get to fix it with the opamp? and i'm more a programmer don't have eletronics background so would be generous if you could show...

do u still need an airco with the leds in a sealed grow room?

mail to tme Hi, I heard from someone on a forum it was possible if you don't buy as a company you don't have to pay vat, if you contact tme before you order. Is this correct can i avoid paying vat? "Is any of the one who order from tme mailed them before to ask if it was possible to avoid...

I didnt want to offend you :) but from reading all pages they recommend around 7 as a minimum, then i point to supra for this number :) offcourse it will work but without a good temp test of the back of the chip you have no idea how warm it is and this will influence the lumen and the life...

has only 5 mm base thickness i think that a little small to be good

Where? :p