Airwalker16,
Thank you for providing feedback and the feed chart. I was using to much nutrients based off your chart. After adding fresh R/O to the reservoir the plants appear to be looking better.
When topping off do you ph the reservoir after adding fresh R/O?
Thanks again!!
Whats up everyone!
I recently switched over to flood and drain in my flower room to try and start a perpetual SOG. I have a 40 site recirculating cloner using R/O with nutrient solution at 5.6 ph 200 ppm. After 2 weeks in the cloner all clones had large white roots. I planted them in 5.5"...
Hey everyone,
First time grower in day 28 of flower. Growing a few different strains ranging in flowering time between 55-70 days.
Do they look to be on track? How do they look overall?
All the plants look very similar to these. Do they really start to swell up now and fill in more or is...
That seems like it could be the issue. I have noticed this on the white widow prior to going into flower. I will pick off all the affected leaves on the plants. Hopefully this will control my issue.
Any other natural ways to get rid of this? I don’t really want to spray anything on the actual...
Hey everyone, I’m in day 26 flower using GH flora series. I attached a couple pics of the white widow leaves that are in question. My other plants leaves are a light pale green with red stems. I assumed I was under nuting when I transitioned over to flower. I have since raised the ppm of my...
Hey everyone,
Could these be pre-flowers and showing sex? It looks like Ninja Fruit #4 showing signs of male. Others possibly showing female. What you guys think
Thanks
I performed a flush last night on the candy glue strain. The plant is in a 5 gallon pot.
The starting numbers:
Going in 1st gallon:
PH: 5.7
PPM: 4
EC: .008
Runoff:
PH: 6.4
PPM: 568
EC: 1.2
The numbers don’t really seem to be off by much starting out. However, the water going in was crystal...
Thanks for all the replies I have learned a lot from this discussion.
My EC from the runoff is 1.72 which seems to be at the upper limit based off some charts I have seen. Being that this is clearly more than what I have been freeding my plants is my coir leeching?
I performed a test comparing...
What do you suggest I do to correct my runoff situation? Keep flushing with lower ph RO water until it reads closer to the range in which I feed?
You don’t think I have any Mg issues?
Should I have an air stone in my RO tank?
Is sulfur causing the purple stems?
My nutrient solution is a lighter brown when I feed and the runoff is really dark brown. I'm not sure how to read the EC reading but in the runoff solution I have a reading of 1720 us/cm.
When I expanded the coir I put 5 blocks in tote and added hot water and perlite. I used tap water
There was a fan blowing directing on the candy glue could this have caused leaf fringe as well? All plants were fed today and I added CalMag into my solution. Do you think I still need to add more Mg? I added 1 ml calmag per gallon