Recent content by DrdankPHD

First your running coco. U might want to get Hanna direct media ph tester connects to Iphone. Just a lot easier to get you ph right in coco. If ec started at 1.5. And run off came out higher 2.0. Your probably locked out. Flush it. With RO water ph correctly. I would prob cut the...

I like it as foliar. Or use it instead of ph up

Well your using cal mag already. Ph it correctly for your media. And test your ppm or ec for lockout

You have. It in a tent.? I would use a tent. Keep it nice and clean. I used sm90 foliar feed. I think it helps me with pest. And there always neam oil. I keep my tents clean. Prune bottom yellowing leaves. Not much help never seen those sort of issues indoors. But I am very careful...

Fan doesn't shut down when it hits desired temp? I did that.

You had good experience with this EBAY electronic stuff? I am little skeptical with fakes. Cheap parts

Yes. U top off with ph water. But u should get ec meter or ppm. I like Hanna new hydro line ec. Most everyone states uses ppm. Blue labs got good meters But basically when u change the res. Write down the ppm. As water Evaps typically ppm go up. So. That why use RO water to bring ppm...

That could take a while. If u know someone in mass. U can grab some there allowed to grow a few plants. Otherwise I would just get some seeds a humidity dome. Heater pad good to go. Clones u need sorta IPM protocol. Could have bugs. PM etc. so u need to be careful where u get them and...

Honestly I use cobs. So I use lux meter. What u do. Raise the lights up and start lowering an inch every few days. And check them after 3hrs. See how the plant responds. Plants gonna tell u. Top leaves will start. This also aclimiize plants to led. I usually use HPS veg. Then go led in...

Res temps are critical. Personally I tried benificals eh didn't really work when u got rot. I try to keep sterile res. I alterate between dutch masterzone and and sm90 keep lines clear. Also keeping the tenet clean important. So I wipe down and loose dead leaves and dirt. Either use...

Which models crap one and good one ur referring to curious ?

It sorta the dark secret of led. Lots of commercial grows have failed cause they didn't know how to use them properly. HPS and CMH. You can use a lux meter. To measure intensity. Led u usually need to use a more expensive par meter for to get accurate intensity readings. I personally...

Op said winter. Depends on Humidty and VPD. Yeah some strains don't like humidity to low. You'll get strange issues.

I think people need to know there learning curve with led. Honestly I like cmh better. CMH and HPS are more forgiving. But I use cobs too because of temps. I like the cree cobs. You sorta have to know your application and have a plan with LED.

That's a lot of questions. Just dm