Harvested my second grow 14-days ago. Was hanging in the tent with 60/60% average over the first 7-10 days. Then with the nasty weather the humidity dropped down to 35-40%. I kept doing the bend test and the only branches that would snap were the very smallest. I decided to run the full 14-days...
I hate to bump an old thread but this was interesting and I have a question.
I just finished my second grow and think I let it get too dry again. For the first 7-10 days I was right at 60/60% and then humidity dropped down to 35-40%. I was doing the bend test and did a full 14 day dry. Buds...
After a good first grow and hanging my plants to dry, I had a family emergency and had to wait 24-hours after they were taken down from before starting to trim. Trimming took about 3 days. I've been monitoring my jars but the RH is staying between 48-50%. I'm assuming this means they got too...
I think it might be the fresh air intake, just surprised at the outside vent they used. The opposite end of the vent leads to a intake vent in my back room. It then goes down to the intake of the furnace and then continues past it outside via the outside vent. So I'm guessing it pulls from the...
It is not the exhaust to the furnace no worries there. It's some type of fresh air intake or something I have never seen before. I closed the damper for now and am not suing the furnace anyway. Exhausts are typically through the roof right?
Thanks for the concern though that could have been bad.
I guess I am bad at typing or explaining today and getting terms mixed up. 1 fan for the exhaust. Then I have a 4in passive intake setup (no fan). I had negative pressure which I identified by the walls sucking in.