Recent content by 92redyj

Anyone? Im also thinking my light is too close. 400 watt Hps about 10-12" away, plenty of inflow, the temperature stays below 85 at the tips of the buds. Also it is not extremely hot to hold your hand at the top of the tips

Thanks for the tips, I will work on. a bigger res immediately. is the one part flora nova bloom adequate to feed these guys? Is there a point when I should just take down the plant in worst shape? do you think they were root bound? Or just the ph problem caused the roots not to develop? I...

I have been using floranova grow and bloom one part fertilizers; Used 300 to 800ppm in veg and then started mixing grow and bloom, 800-1000 ppm after switching to 12/12 then upped them to around 1500 when it started yellowing. I have also been using 1-3 drops of superthrive per gallon with 3...

4 plants, 30 days into flower, the one has almost completely yellowed and shed it's leaves, the flowers are burnt at the tips and pretty crispy.....the others three are starting to look yellow at the top, which happened first, then begin yellowing fan leaves from the bottom to the top. My...

I flushed with ph 7 water about the volume of my pot(6 gallons) and saw NO improvement in the runoff ph. That was all the water I had prepped. I'm planning to let it dry then flush one more time with 10 gallons of water. Then I will wait two days and put it into 48 hours of darkness then...

I started with 2 plants in soil with the goal of putting clones in a hydroponic setup. I built an ebb and flow system and transplanted the runt of the two plants that looked unhealthy into hydroton, that one ended up turning hermie. I used 100% miracle gro and then transferred the plant in...

Thanks for the reply, I was searching and found this. I went with the wood frame and screen and it is working like a charm. I just picked up a smaller hydro-farm table with 6" pots for vegging.. The table only floods 3" or so, and that is after I modified drain tube. I am starting in...

I don't think there should be any nute burn.... Unfortunately I was anxious to get started and started this in 2 gallons of Miracle Gro Potting Soil. I transplanted to this big 6+ gallon container and filled with a mix of perlite, peat moss, and moisture control mix. I have only added a small...

Any other opinions? Is it likely that the hermie was able to pollinate the other plants? It only had two male flowers that were only a few days old. What are other signs of pollination to watch for?

I removed the hermie as soon as I noticed the male flower. You all agree that is a male flower, correct? Here is the hermie plant, it looked female for the first 2 weeks of flowering, and didn't start showing any signs of sex for almost 10 days. I thoroughly combed the plant after removing it...

Plants are 2 weeks into flowering and on some of the tips the pistils are shriviling and browning, I also just found 2 male flowers on a plant that was living next to it. Pictures of male flowers also. I have read something about browning pistils being related to being pollenated. Is that what...

Anyone else want to verify before I cut it to pieces and put it down the disposal?

Those are male flowers fo sho right? Also, I topped this plant and rooted it a few weeks ago, I have it in veg now. Should I ditch it as well or flower and watch closely? I'm looking to make some long term mothers so if this plant is going to continue to be likely to keep hermying I'd like...

Well I pulled it off my table, hopefully I'm not too late removing it? I examined the plant thoroughly and can only find two of these "male looking suspects" both are pictured below....... Lots of female flowers! Suspect 1 Suspect 2

This plant has had a very hard life.... Started in soil, was looking to be in very poor health so I transplanted it to an ebb and flow system. The transplant was hard on it and I was overwater for a month by flooding my table every 15 minutes. It took 5 weeks to root and start growing. It was...