Fert ? & plant issues. please help !

Ok bare with me im new .
I have a bubba kush plant in flower 3 weeks was seeing issues a week in & talked to our local shop guy and he says I was over ferting so I cut back as he recommended. I am in DWC using air stones I keep my water temp at 68, pic below shows what he said was over ferting. I was mixing as the label called for and after mixing I was 720 ppm he said I should be no higher than 480 as my water out of tap is 80 ppm sorry I had no ec info still not getting that part. I change my water once a week check my ph once daily I have changed water twice since I lowered my mix & now I have a new issue of yellowing, pic's included
Indoor Tent with fans, Led light
Room temp average 70 night 75-80 day
Normal humidity for my room 44 give or take
As of tonight's check my numbers are.
PPM 411
For EC my meter reads 0822 us/cm , im still lost on this .
PH 5.6
If i missed any needed info or my post it to much please let me know.
I am using Canna Aqua Flores & I add some cal mag pic included
Any help would be greatly appreciated !
 

Attachments

Last edited:

Logan Burke

Well-Known Member
PH of 5.6 is acceptable, but it's right on the cusp of being too low and making certian nutrients inaccessible. Try bringing it up to 5.9-6.0 and see if that helps...it is definitely a nutrient related issue, whether or not it's related to PH idk, but its my best guess...you haven't had your LED's really close to the canopy have ya?
*EDIT* Did they do this before, or after lowering your ppm's as your local hydro guy recommended?
 
PH of 5.6 is acceptable, but it's right on the cusp of being too low and making certian nutrients inaccessible. Try bringing it up to 5.9-6.0 and see if that helps...it is definitely a nutrient related issue, whether or not it's related to PH idk, but its my best guess...you haven't had your LED's really close to the canopy have ya?
*EDIT* Did they do this before, or after lowering your ppm's as your local hydro guy recommended?
i had a lot of tip burn the store told me that was fert burn so i cut back and now its yellowing all over. after seeing more and more i mixed more the nutes to a middle a number hoping to see it stop but it is still yellowing. some leaves are now clearly dying off should i go back up or am i going to shock the piss out of it .
ADDED: i am putting my ph right at 5.8 now
 
PH of 5.6 is acceptable, but it's right on the cusp of being too low and making certian nutrients inaccessible. Try bringing it up to 5.9-6.0 and see if that helps...it is definitely a nutrient related issue, whether or not it's related to PH idk, but its my best guess...you haven't had your LED's really close to the canopy have ya?
*EDIT* Did they do this before, or after lowering your ppm's as your local hydro guy recommended?
leds are now at top of tent with breathing room and extra small fan up there for heat .
 
King plus 600 watt and 300 watt topolight that came with my starter tent . i was about 6 inches lower have been raising them as the plant gets closer , i try to leave at least 8 10 inches away at minimum

Tried to post links i guess i am not allowed still.. Have no fears the only porn im posting is my naked buds ...
 
When you increase your PPM go low or no nitrogen. Cal mag should have that covered.
I am only using the Aqua flores A/B and the Cal mag nothing else . As for the PPM im at around 600 now and i was going ot go back up a little more to like 650 i was up at 760 when i was getting the burn i went down to 550 and its yellowing
 

Attachments

Top