Yellow roots in DWC
- Thread starter jensen71
- Start date
Eric Farley
Active Member
I'm still new to growing but as long as the plant is healthy and the roots don't turn brown I wouldn't worry too much. I'd suspect it's because you're nutrient solution isn't clear and that can stain the roots the color of the water.
Another possible cause that you should correct is if you're using tap water that hasn't been de-chlorinated the chlorine can cause damage to the roots.
Another possible cause that you should correct is if you're using tap water that hasn't been de-chlorinated the chlorine can cause damage to the roots.
Vumar
Well-Known Member
Any air stones/pump? I don't see any in the picture. That's also a problem if you are relying on your waterfall to provide your DO then it needs to be a longer vertical drop for DO to be absorbed.
jensen71
Well-Known Member
see pic of aqua vita commercial air pump 38lpm output (this is suspended in mid air by rope ratchets) at about 1 foot above the top of each bucket:
see pic of red frog 9.5 inch diffuser ring
the feed is pushing out 6-7 gallons of nutes at 250gph into each bucket from water spouting into the water from a hole at about 3 inches from the top of the bucket, the water line is about 6 inches from top of bucket which is 14 inches high. the feed is coming straight out the side and immediately falling down within a few tenths of an inch of the net pot so its coming in at 90 degree angle where there is no elbow. The feed is at about 11 inches and is coming through a 1/2 inch hose.
see pic of red frog 9.5 inch diffuser ring
the feed is pushing out 6-7 gallons of nutes at 250gph into each bucket from water spouting into the water from a hole at about 3 inches from the top of the bucket, the water line is about 6 inches from top of bucket which is 14 inches high. the feed is coming straight out the side and immediately falling down within a few tenths of an inch of the net pot so its coming in at 90 degree angle where there is no elbow. The feed is at about 11 inches and is coming through a 1/2 inch hose.
jensen71
Well-Known Member
I went to a store to check out prices on peroxide and explained to the guy what I was seeing. He said it's probably residue sediment from the hydrotons. There is no slime on the roots, just sediment and the peroxide will bleach the yellow out of the roots. Can I run peroxide through hydrotons to get rid of all the excess coloring and dust? Can I run it through the entire system or will my filter continue to clog until all the sediment is wiped out individually at the bucket level? Also, whats the minimum strength of peroxide that I can use for the purchase of whitening the roots? I think the H2O2 oxidizer is diluted to 29% from 35% which still remains high and will burn skin if rubber gloves aren't used. I take it the local CVS or Walgreen's H2O2 isn't strong enough being diluted to 3% from 99%.
Vumar
Well-Known Member
You will see clay sediment in your system if this is the case. You will see it floating in the water if you scoop some out or turn the water pump off and wait 5 minutes for the water to settle. Can you show more of the system other than the one small picture? I'm trying to help ya out. It could be the light leaks from the tubing and orange bucket. Any flavoring added (contains sugar which feeds bad pathogens)?
Northofimjin
Active Member
I know I've had clay dust from my pellets even collecting on the tin foil I have around my baskets if the nutrients solution stream is flowing across it. But it's never colored my roots. I use two large cylinder air stones and every time I change my res water once a week I add a tsp of Hydroguard to each gallon and Ph at 5.8. Haven't had a problem.
Attachments
jensen71
Well-Known Member
The water level was about an inch above where the bottom of the net pot is, ive lowered tank levels to bet a about where the net pot touches the water. Haven't but H2O2 in to the root zone yet, wont that kill bacteria? Is there a safer dilution % of H2O2 that can be used in lieu of the 29% (diluted from 35%)? I can't use cheap pharmaceutical 3% H2O2? I don't want to burn the roots by accident if the hydro strength of it as a cleaner is so caustic that I need gloves to handle it. Also, will this kill root zone bennies like microbes, bacteria, and fungi? The roots themselves look nice and stringy with mini branches but some have dirt/pellet clods stuck to them. Not sure what it could be, but before I go down the peroxide path, just want to make sure I'm using the right strength for the right purpose. No aquarium smell that I can tell of. Just smells like nutes.
Vumar
Well-Known Member
Your tin foil doesn't reflect light but rather re-directs it. This re-directed light turns into heat spots on plants xD
