Dual 120mm Fan Intake w/ pics

DO3SHA

Well-Known Member
Had a single that i made which was shit but worked.:shock:


Tools:
Razor Blade
Sharpie
Tape
Hot Glue Gun
Soldering Iron
Drill w/ Drill Bit and Phillips
Metal Cutting Scissors

Materials:
Mix match on some Tupperware
2 120mm 12v PC Fans
1 12v Power Supply
8 Screws To Hold Fans



Step 1

Trace your design of the fans on your container as so.
Also Trace the opposite side for the size ventilation tubing you are using.
IMG_0218.jpg

IMG_02111.jpg

Step 2

Carefully cut out the wholes so the air can pass through as so.
Carefully drill out the wholes for the screws.
IMG_0212.jpg

IMG_0219.jpg

Step 3

Drill a whole for the power cable.
IMG_0214.jpg


Step 4

You must run power cable through the whole and screw fans in before you solder.
IMG_0215.jpg


Step 5
Soldier all connections and test to make sure fans are working.
IMG_0213.jpg

IMG_0216.jpg


Step 6

Hot glue wires down so they do not move.
Note I put hot glue over the solder points so i did not need to use tape and the points would not touch.
IMG_0217.jpg


Step 7

Hot glue the back side together and make sure all seams are glued to avoid air leakage.
IMG_0220.jpg

IMG_0221.jpg


DONE!
voila your done, simple cheap and easy.
IMG_02221.jpg
 
Great design, love it. I think I may do something similar for my outtake pulling through a DIY scrubber. Nicely done. Thanks for the pics.
 
Looks great. I'm probably going to use that in my next grow.

Is that an intake into the grow room? Surely it's the out?
 
Yea it's an intake and it's for a T5 tent grow that I'm doing it's total intake is 112 cfm While my inline in the tent is 240 they match up pretty good thanks all
 
Back
Top