I was wondering if anyone knew of a way to get just the thc out of resins??
ive read that i joint other then a vaporizer is the best way to get high u get the most thc and least toxins there for get higher. no supposedly a water pipe could be better for u then a pipe due to the fact it can filter out some toxins but maybe not they say the regular pipe absorbs as much as 30% thc if so after u smoke out a pipe for months shouldent the resins be full of thc if so is there any way to extract only the thc and leave out the resin to make a pure thc smoke???if so what is the best way to make use of pipe resins??

This looked a little confusing at first, but I think I understand...

You should be able to extract any minute amounts of THC, and probably (but not likely) clear some of the crap from your bong resin by using the same methods as hash oil extraction (solvent, safe boiler, a little water, OUTDOORS). You would still be left with some tars etc though. You'd probably be better off just scoring a big bag of leaf from your dealer and extract oil from that. If you get the leaf free, you can't go wrong.

TIP: Use eucalyptus oil or tea tree oil to clean your pipes etc. A little of these oils will break down even the toughest of pipe resin blockages. The crap from the pipe is not smokable after cleaning though...and rinse your pipes and cone pieces thoroughly in warm soapy water (then rinse well) after cleaning with these oils. They are both antiseptic, with tea tree oil being an extremely good fungicide. If you live in the tropics, Tea Tree oil is the very best way to heal Tropical Ulcers.

__________________

It's Medicine Jim