Mexican airlines auto grow

Germama

Well-Known Member
It's actually worse but if u have to use make sure it's the dull side u put facing plant not shiny as most would think. Good luck
 

Germama

Well-Known Member
Also autos are very sensitive so any future transplants will stunt growth too much to recover usually start autos in same pot to be finished in for future grows.
 

borbor

Well-Known Member
your walls and floor are white, the foil is hurting more than helping, with a flat white wall or floor the light is reflected evenly, the foil has crinkles that reflect it randomly and concentrate a lot of light/heat in small spaces and leave other spaces with less, also, probably reflects less light than your white walls
 
Day 18. Gonna start feeding it from the GH performance pack I believe I can start with the micro and gro along with the rapid start and floralicious image.jpegimage.jpegimage.jpeg
 

Germama

Well-Known Member
Are you using AN nutrients I started that in coco at week 2 with no prob +cal mag on day 47 of GC
 
I dunno what AN is I got the general hydroponic performance pack this is my first time ha. Do u use the calmag bc of a deficiency or is it good either way? Green crack right??
 

texasjack

Well-Known Member
Hilarious strain name. Subbed
I haven't flown on a Mexican airline since the 90s but then the stewardesses were beautiful young women and alcohol was free. Good days for college age me.
 

Germama

Well-Known Member
I dunno what AN is I got the general hydroponic performance pack this is my first time ha. Do u use the calmag bc of a deficiency or is it good either way? Green crack right??
Yep and AN is what ur using advanced nutrients used cal mag because of coco no calcium in it.
 

prostheticninja

Well-Known Member
You should put a reflector over those bulbs so you they throw the light down. It can be hard to get a reflector that does the job, but this is my set up: image.jpg

As you may or may not be able to see, there is a red wire that runs down the center of my reflector. That wire supports my lights and holds them up. How that happens is that I thread the wire through the more rectangular opening below the spiral. It hangs the CFL bulb very nicely and it is impossible (unless the glass snaps in half) for your light to fall. Using insulated, copper, wire ensures that it will never break or fray. You can also find wire that is rated for much higher temperatures than the surface of a CFL bulb so you do not have to worry about a potential fire hazard.

My reflector is just a simple aluminum wing-style reflector that I got when I bought my 400 hps. It just so happens that this reflector fits perfectly in my current grow cabinet. Anyway, this reflector has two holes on each side that are like a colon ( : ). In these holes I have tightened a zip tie to act like sort of like a tie down point. image.jpg

That tie down point does two things: it allows me to attach the hook for my ratchet pulleys; and it gives me something to wrap the supportive wire around so I can zip tie it to itself after I wrap it a few times.

I can't really recommend a certain type of reflector or anything if you decide to do this, but I recommend the method of reflection whole heartedly.
 

prostheticninja

Well-Known Member
My oh my, those are some nice looking leaves. I like the short style with the really broad leaves. I think you're in for a real treat, come late flower and harvest.
 
Top