Driver question

I have a couple of quantum 288s that I'm fixing to put into service. Thinking I may wind up getting 1 or 2 more at some point in the future. Is there a driver that I can use with 2 boards that would also drive 1 or two more when I'm able to get them?

Helps to work backwards-how hard are you planning on running each board? HLG says a sink is required over 50W. Once you have an idea of the drive current, forward voltage is just added for each board. A constant current driver lists the voltage range it's capable of delivering rated current. Just pick one that fits multiples of your board voltage.

Yeah It seemed like it a cv driver would be the only driver that would allow expansion with the capability to run each board hard. For the cost of the cv board I can get 2 cc drivers. Think I’m just going to go that route. Thanks