Search results

Coming back to this just in case it helps someone else. While the pH might be slightly off, I've gone to feeding them a little and watering a little. VS deep feeding or deep watering and letting them get droopy before feeding or watering. This seems to be working better and they do seem quite...

Okay, using my calibrated Apera PH60, the nutrient solution mix has a pH of 6.78. Not sure how to do soil with it yet, need to figure that out. Soil test kit from a local chain hardware store shows the results pictured below, which is a composite picture. Kind of hard to capture the right color...

I've been feeding a diluted percentage of the 1 gal mix, about 50 % strength for every feeding. I'll dial in the pH as you suggested and go from there.

Not sure on water pH, it's distilled water. Still need to get a meter for that. Soil pH is at 7 Nutrients were listed in the post. "Nutrients have been 1 gal of water with 1 TBS Roots Organics, 1 TBS Age Old Grow and 1 tsp of General Organics Cal/Mag. " Whole plant shot . Going back to the IC...

I can't tell if this is K or Mg deficiency. Reading around and checking the Cannabis Grow Bible has me leaning towards Mg. The grow bible shows a specific picture called " praying for magnesium ". Which the second leaf pictured is doing. Just seems to be on the bottom leaves for now. Growing...

Another great order hit my door today. The amount of freebies was insane, all I can say is thank you @Bad Dawg . And this case is freaking cool.

Trying to learn as much as possible with reading and just pure hands on growing. So far everything I've done has been female. I'd like to grow a male, if I can get one to pop..., to save the pollen from. Since I'm just keeping what I have in veg to learn from until I understand how to treat the...

Thank you for the suggestions. Found a candidate, just need to wait until payday on Friday. Still super stoked that I've got a reliable seed bank in the US that I've had nothing but success with.

@Bad Dawg , any recommendations on a strain to purchase that would be good for sleep ? I've really enjoyed growing Kinetic Genetics Intelligent Design because they come in packs of 20 but am wondering if you've got something better suited for sedative effects?

Did some searching, while there were quite a few results, they didn't really apply to my question. I've got two plants culled today, both in one gallon pots. One did not take well being transplanted from the solo cup. The other did well with the transplant but am just not happy with the way...

Had to tape the outer cups to get them dark enough to cover the roots properly. TDS meter says the Nutrient water I made is at 41 PPM with just the Age Old Grow. Which is good because there are two more nutrients I'd like to add to the water. Roots Organics Trinity and General Organics CalMag+...

I do have colored cups but went with clear to actually see how dry the soil is all the way down. Holes are in first cup, second cup has a spacer to raise the first cup up and catch any water that drips. Didn't think about roots not liking light, will correct that right now.

Interesting. Was going to wait until week 3 to feed, as it's only been 12 days since planting from sprouting but they already have a 3rd set of leaves coming in. TDS meter on order, arriving tomorrow.

Kinetic Genetics Intelligent Design Soil is Nectar For The Gods #4 Light is QB96 V2 at about 45%-50% on the potentiometer, About 15 1/2" off the canopy RO water only Planted 2/18 Had planned 20/4 light but noticed the timer was stuck on 2/22 from rotation because it was in contact with a cord...

So I'm doing a super simple, one light grow with 5 plants. Objective is to end up with a Bonsai Mom or two. Not harvesting, just growing a bonsai. Went with clear cups this time so I could actually see how wet/dry the entire cup of soil is. Using two cups for each plant. One with holes in the...

Meter was hooked to driver output, LED and shunt. I've got the potentiometer turned to about half rotation, no fires yet. Might be I just don't understand what the meter is measuring. Thought it was supposed to show what the Driver was putting to the LED. I'll have to measure with a proper...

This picture really helped me to try and get the meter setup but fear I might have wired it wrong. The amp readings I'm getting are way out of spec for the QB96, unless I'm completely misunderstanding how the meter works and what it's actually measuring. I thought the meter was supposed to...

The way I am reading this: Had to extend the white portion to see the text.

Yes, it's a bit confusing since I've never wired something like this before. If it were a straight shot, with no meter, that would be simple.

Recently moved and am unpacking all the LED things for a single light setup. I've got the LED, Driver, Meter, Cord, 18 AWG Solid Core Wire, 2 Port WAGOs and the Potentiometer for dimming. Can not for the life of me find the bookmark that explained how to wire them properly. Can anyone explain or...