I have and area 25in wide X 16in deep x 37in tall. I plan on using a 3 gallon bubbler bucket and start with 3 plants. i will only take one plant to full bloom in this bucket. I plan on using one 70w hps and 1 or 2 42w cfls to the end. If i can afford it come flowering i will get one more 70w hps. I know height will be an issue but if I veg for only 4 to 5 weeks and FIM or top the plants, could i get away with 1 OZ of good smoke? I will only use bag seed as this is only an experiment, to take a few plants to maturity using hydroponics. Testing for future runs when i have more space and can set up my 400 w hps.

I for got to add I can extend the height about 12inches or so. I figured that using the 70w hps and the low penetration of the light throught the plant, i should keep the plant short and bushy, there fore the height would only be for weak undeveloped buds.

Here is a drawing of what i plan to do. Any input is welcome.

well thought out, make sure you test this area before putting plants into it.

it looks good.

nice drawing too

Thanks Russor. I plan on running it for 48hrs just to make sure i will not have too much heat build up.

Videoman what do you think about this experiment?

i don't see video around so far, so i tell you my thoughts on this

have you figured out some ventilation for your grow so far, you will need fresh air vent intake and some ventilation insides to keep the air moving so that the plants get their CO2/O2. also should this take care of your heat problem you will face for sure.

but on everything else, it looks like a great set up

__________________
keep the thumb green and the gun oiled, !

Green if you look at the drawing I have above, the two things on the top of the box are pc fans. What do you think the cfm rating should be?

Dose any one know what the cfm rating should be for my pc fans?

No one has any idea?