Tyke 4873,will be building another cloneing room that will accomadate up to about 9 plants this is ideal if you are starting a cannabis libary. So watch out for the daily info:first things first this may sound a little big but don't worry i have been a joiner for near on 28 years now so you get stuck get back intouch through the site.10 pieces of 8ft 3/2.ince this is for the frame today we are gonna build a small ammount of it.first take 4 of the 8 ft bits of wood get [rougth sawn] it is alot cheaper to buy then p.s.e[plain side and edge]first things first take 4 of the 8 ft lenths if they are alittle smaller don't worry has long has each section is the same lenth.the 4 8 ft lenths are the sides.then cut 2 of the sections and cut equely in two.then nail the tops 8ft lenths to the 4 ft lenths make sure that the 8ft lenths are in the inside with the two 4ft bits on the outside.it is now the makers decision wether to have it on its side this will give you a cloneig room and somewhere for those mothers.don't worry if it sound a little big because you are going to have a nice cloneing room at the top.we will also be needing some mylar for the bottom 6 ince of the mother room you can use white and black backed viscren if desired.be back on tomorrow with round two of the cloneing mother room .but if the room that you are growing in now this will be right up your street see you tommoror.