amp not coming out of protection
Amp is not coming out of protection...i hook it all up 2 days ago, it worked for 30 seconds than i turned the car off and arranged everything and put everything back together.....started car 10 minutes later....when for a 10 minute ride (worked fine).....got back in to come home, half way back it shut off and went into protection....after it sits a while it might come out of protection but if you turn the volume up alittle it will click and go back into protection....it last came out of protection last night....turned it up(went off)....ever since then it's been in protection (almost 24 hours).

i just hooked up a Boss 3600 watts Max, and a Pioneer Premire 3500 watt max(1000 rms)....the amp has only one output on it for one sub....and the amp is 1 ohm stable....the sub is wired as 1 ohm.......anyways.....

i hooked them up in a 06 equinox with the stock radio still in it(so i used a line out converter)...but the line out converter is only hooked up to one stock speaker because their is only one stock speaker in the far back.

i hooked up the wires as said, but not sure if it's for 2 subs to be hooked up or not (cause i'm only hooking up one).....but the wires coming out of the line out converter are....
RED = hook up to 12+ on the amp
Blue = hook up to remote wire control on the amp
Green = hook up to + wire line on the car's stock first speaker
Grey = hook up to + wire line on the cat's stock second speaker(which i just hooked up to same wire as green
Grey w/ black stipe = hook up to - wire line on the car's stock first speaker
Green w/ black stripe = hook up to - wire line on the car's stock second speaker (which i hook up to the same as grey w/ black stripe)
Purple = hook up to green w/ black stripe (this one is just to get a 12+ volt for the remote turn on to work on amp)

did this all.....hooked up rca cables to amp and other side to line out converter...

power cable to battery and amp (w/ breaker) is good

ground is good

can anyone firgure this one out, or help, thanks