I did read that AISI-316 is recommended for salt water applications because it shows good resistance against chlorides. Do you know how strong is the nutrient solution compared to salt water???
Where you read the information that it generally withstands acid solutions up to 3%?
Do you know if...
oh yes, sorry. The question was intitially about the co2 heater. Actually I was also thinking a lot about the other pumps which I need, so that is why I got it mixed up :-D
Thank you for the information.
Btw how the shut off valve is controlled? With a main controller like for the lawn...
I am asking there is differences between types of stainless steel and if there is needed stainless steel grade for salt water or if the type below (AISI-302) is already good enough?
I am wondering if AISI-302 stainless steel parts are suited for permantent contact with the nutrients? It is because I am thinking about using a non return valve which in the reservoir which has AISI-302 grade parts.
I don't know how aggressive the nutrients are to metals and if this kind of...
Thank you!
A pole barn is sort of a shed???
Are you happy with that pump? It is not too strong?
The pump is not doing vibration noises?
I looked at your pictures, there is a tap at each plant. The pump is pumping at all the taps at the same time or how does your feeding work?
At some times I need to carry daily two 8 gallons (2x 30 liters) of water to my grow room. But they are super noisy while carrying because of swashing sounds.
I am using these kind of canisters (see picture)
Problem is that you cant fill them completely with water. The water inlet sits a bit...
Thank you very much! I will these instructions in mind.
"As for the sizes, 400-500 on the barrel and 200-300 in an active res"
What is it, gallons per hour, or liters per hour?
ok. I also need for my clones and mother plants a pump. they have a different reservoir and table.
How strong is your pump? How much watts? I am wondering if a sump pump can shoot the water too strong? Actually I see they are even cheaper then aquarium pumps...
I dont want to use airstones.
I need to floom a rain water barell with the size of around 500 liters or 130 gallons.
And then I need to floom also a 150 liter reservoir or around 40 gallons.
I am not really sure what pump (specs) I should choose for flooming.
Also how often I need to floom...
So far it is working. The flojet pump and the eccotemp gas heater. But unfortunately when it is operating there is a humming noise in the whole house. It is coming from the pump and from the hose attached to the pump. Can you give me advice how to install the pump so there is not much vibration...