I would veg another week at least.
If you're doing a true scrog, you'll want to start intertwining the new vegetation along the screen until its about 50-60% full. Once you switch to 12/12 the plants will go through a huge growth spurt. Keep filling the screen.
Looks like they got hot. Same thing happened few months back.
Harvested buds were less dense and some burnt crisp sections had to be cut off.
Maybe do a foliar feed an hour before lights turn on to add moisture and make sure the temps are good.
Good luck
Don't have too much experience with soil. If you confirmed its not bugs/mites then its a nute deficiency.
Check out the image attached
Maybe K? How long into flower stage are you?
Check this out. https://www.rollitup.org/marijuana-plant-problems/118601-guide-plant-deficiencies.html
I've worked with a similar setup. You're good with the air stones in the resv to supply enough oxygen to the roots.
No need to open up aero grow chamber separately to allow air in. Just make sure your watering schedule is sufficient.
IMO, don't use the yellow leaves. Only use green leaf.
Run 2 batches of bubble bags extraction. 1 with the large fan leaves and stem plant material & 1 of prime trim off buds and small leaf around bud.
Not sure how you plan on using the bubble bags, but the the dry ice method with a 220 & 73...
I came across this basement hydro setup in the past. Check it out, I'm sure you can get some good ideas.
https://www.rollitup.org/grow-room-design-setup/153039-memaws-big-hydro-basement-setup.html
To minimize floor space and maximize growth area, I would install an AC in the wall at a good...
I have an ART-DNe C.A.P. Adjustable Cycle Timer. I like that I am able to set any ON-OFF cycle that I want so easily, but I'm wondering if anyone else has this problem with the timer clicking before turning on.
I have the timer set to [5 min ON / 45 min OFF] There are some times when the timer...
The recovery is going ok.
The upper branches have recovered and regained semi-strength.
The lower/smaller branches probably will not recover. Some of the wilted leaf has already started to dry.
Any advice with this situation? I'm sure I'm not the only one whose pumps died...
Thanks dirk.
I know not getting water has hurt these guys. yikes! I'm not expecting a 100% recovery, just hoping for them to stay alive.
Aero has been an experience to get accustomed with. It definitely requires a lot of attention!
I will post updates on the recovery.
[keeping my fingers...
Went on holiday for 2-3 days and came home to discover 2 pumps in the system failed. The light schedule and temp/humidity range has been stable, but 2 of the guys are severely wilting and droopy looking. The whole plant is wilting bad and looks lifeless. :neutral:
It is still green and wet...
Thanks guys. In the past for my soil grows, the guys got huge with the 1000W HPS.
I raised the 1000W hood until I can switch to my 600W MH setup.
I want to pickup a FLO T5 fixture to place inches above the these little guys.
Any suggestions on the Great White powder and how I can keep it...
I must note that the largest of the 4 little guys has a root that has not only grown out beneath the rockwool cube, but also out beneath the 6" net pot. This is encouraging that there is root growth, but this little guy also is showing the most yellowing in leaves. Also, has the largest brown...
Ive done a couple grows in soil that were successful, so I'm not sure if I may be over-analyzing my current aeroponic setup but I am definitely in need of some advice. Any and all suggestions are welcome, please :mrgreen:
I used the paper towel method to sprout seeds - took about 2 days.
Then...