Recent content by P0w3rGr0wZ

okay cool. I have the speed controller all ready also. I will try the 8" to 6" if that does not work well I can just make the hole bigger later. Thanks

I have an 8" 750 cfm. I wanted to know if I needed 8" duct or if I need to go 9" and clamp or tape it? Also I will be venting to attic so I wanted to know when I put the hole going to the attic if I can make it a 4" and just get a reducer say 8" to 4" or will that back things up trying to push...

Thats cool if it gets cold I have space heaters. It just seams like it is easier to heat up the place then keep it cool.

okay got it. thanks for the help.

I just ordered my Inline Fan and I bought a Hurricane Inline Fan 8"inch 745 CFMd I go to order my Filter and I notice it says Phresh Intake Filter... Got me thinking... So I think it is a knockoff it is almost $100 cheaper than the other Phresh Filters I saw. I can't believe people try and...

If I run a 8"x16" rated at 750 cfm and I run a 745 cfm fan on half speed, will the filter still work properly or would I need to get a smaller filter to compensate having to turn the speed of the fan down? Also If I ended up with heat problems and had to turn the fan up I would be pulling too...

Do you think it would be too much fan and filter? I was thinking just turn the fan down but I dont know if the filter would still work if I did that? I am sure I would not have to run the fan on high 24/7 but will the filter work with the fan only pulling half or low settings??? Point of going...

I think I am going to get either the 6" x 16" 750 cfm filter, the 10x12 700 cfm, or the 8x16 700 cfm. Will a 720 or 745 cfm inline fan work here or do I need to go bigger if i get the 6x16 750 cfm? Do you think these are overkill? I just want to make sure there is no smell. And how are the...

Sounds good. I think with a new intake though instead of getting intake from the attic as well maybe pull fresh air from under the house? This was my original thought. Thanks

Also Suggestions... Should I go with the Phresh 6x16 400cfm or the 6x24 500cfm? or is that over kill? room is 2.5 x 3.5 x 5 I want to keep smell to a minimal low as possible.

Here w go which one of these would be best for closet? Just trying to do this correct. http://www.youtube.com/watch?v=xE61JM9dRlQ I duno if I can post links guess I should check...

Thinking more on this, what about making an exhaust in the ceiling to the attic have my ducked run from the room to the attic where I mount my fan and filter. The ONLY thing I don't know if it is a problem or not is having to push the air through the filter to be scrubbed. It would be outside...

Just hang it on the inside in front of the door and roll it up everytime im in there? *Edit NVM I think I might just try a piece of weather stripping... I don't know why I did not think of this in the first place.. DUH

I have a couple of points where the light is leaking inside the closet. I hooked up my light to test it and walked outside into the hallway and I can see the light penetrating through where we have the HVAC box installed. Anyway I went back and caulked it and it mostly fixed it except a few...

I hooked up the light just to test it and it seems to run fine. I also have my pc and tv hooked up and everything seems to be good. I only ran it for an hour to see how hot it would get and it jumped from 77 to 85 in the closet with no ventilation and fan hooked up yet... There are no grounds on...