Recent content by ns420

Did some checking tonight... RH, Temp, and co2 ppm are the same in both veg and flower rooms so I have to assume my air circulation is doing the job. Spent some more time eliminating any possible air leaks... hope I see a big improvement!

Should I relocate my vents to the floor? This wouldn't be hard to change for me.

Don't you want the majority of the co2 to stay in the flower room?

So you guys don't see any problems with how my air circulation is setup?

I covered the drywall with 3/8" fiberboard paneling with trim pieces over all seams... and there's panda film covering that with all seams sealed with gorilla tape. Doubt the lack of a vapor barrier is making any difference. Adding a vapor barrier isn't an option at this point.

I'm not sure what I can do to seal things up any better... I gutted the room and put up new drywall, caulked all my seams, walls and ceilings are covered with panda filmed and all seams are sealed with gorilla tape, I have no exhausts pulling air out of my grow room... doors are covered by...

Hello all. I recently designed a sealed grow area with co2 enrichment. I used a 20lb canister of co2 with a regulator connected to a Titan co2 monitor / controller set to 1500ppm. I have 24 plants total, 20 in early flower 4 in veg. In just over a week the tank was empty. The rooms are sealed...

With the $99 add-on it does, making the total cost of the unit $350 or so shipped. But it also does remote temp, humidity, and co2 level logging and monitoring which is nice.

Yeah I was aware the controller addon was $99 more. I found the Titan Controls Atlas 2 for $180 shipped... looks like it would do the trick for controlling and monitoring co2 levels and costs a lot less.

Hello, I am converting a previously unsealed grow to a sealed grow and adding Co2. I need some advice on what combination of Co2 controllers and monitors I should get. I am looking for the most inexpensive combo that will do the trick. I don't need super accuracy, just something reliable...

Hello, I am converting a previously unsealed grow to a sealed grow and adding Co2. I need some advice on what combination of Co2 controllers and monitors I should get. I am looking for the most inexpensive combo that will do the trick. I don't need super accuracy, just something reliable and...

Averaging 400-600 grams (dry weight, depending on strain) from each 600 watt bulb each harvest, which I think is pretty good for no co2? Don't have anything to compare it to.

I feel I am. I am very happy with my results at this point (except for what I am spending every month in electricity) and feel that eliminating any potential for insects and increasing the Co2 to optimal levels will give me a good increase in yields. I have my nutes locked in, optimal temp and...

I have been looking into this and plan on building a couple of heat exchangers. Eventually I want to add solar heating to my house, shed, barn, and workshop. Here's some of the links I saved with DIY tutorials... http://www.n3fjp.com/solar/comparisonhotair/comparisonhotair.htm...

Well I am using digital thermostats and timers to control my temps, my dehumidifier can be set to maintain a certain humidity level and I have it on a timer to only run during the lights off during the summer. I'd love to add a controller but at the moment it's cost prohibitive. With my ACs and...