I got them here but they aren't available atm. As for the neon green caps I 3D printed them out of flexible tpu filament.
https://www.amazon.com/gp/product/B09WJSVXLD/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
I was going to post about this too. I had to prop the front up too because the first 2 days of using it I open the door and water poured from the front of the door.
I have been growing for over 13 years and in the past 3 years, I started to have an allergy to cannabis. It's the worst when I'm trimming or if I go into a dry room. I sneeze for 10 minutes straight and my eyes water. It sucks! Now all my outdoor buds are washed before drying. This helps remove...
Here is a few pictures of the finished product. I designed and printed a few wire plugs out of flexible TPU filament for the first 2 back panels and a housing made from PLA that screwed in to the sliding back panel for the dehumidifier power jack.
I finally got my Koolatron after a fail order from Amazon. The tracking was saying out for delivery than a few hours before delivery time it changes to item was damaged and shipping back to sender. I tried ordering a replacement on Amazon but they were sold out :wall:. I guess everyone is in...
HSC Squirt. This strain was a pain in the ass to find a pheno that didn’t herm. I went through 2 packs and finally found a purple pheno that didn’t herm.
Bud rot is a pain in the ass. I had it really bad 2 years ago and it took over like wild fire. A windy day will spread those spores so fast to nearby tops.