Recent content by Drfeelgood420

  1. D

    Leafs curling down

    I thought I was nitrogen toxicity so I emitted the base nutrient and added only MOAB. I see the problem now. Thanks
  2. D

    Leafs curling down

    And I've used mother of all bloom 0-50-30
  3. D

    Leafs curling down

    I thought it might have been a nitrogen over load
  4. D

    Leafs curling down

    Canna coco A+B week 1-4 I was going g to switch to heavy Bud A+B for week 4-8
  5. D

    Leafs curling down

    The question is how come they're not getting burned if they're over fertilized
  6. D

    Leafs curling down

    Also I see red veins in the fan leaves on some of them
  7. D

    Leafs curling down

    Highest I went was 1010ppm. After I noticed them curling down I went down to 600 ppm, still didn't go away so I did a flush and regular water feed, and I did a revive feed by advanced nutrients. My run off water is at 420 ppm 5.8ph It's been over a week now
  8. D

    Leafs curling down

    I am starting week 4 of flower and the past could of days the leafs have been curling down. I am growing in coco coir. I have stop with nutrients and did 2 flushes and gave it some Advanced nutrients Revive. not sure what is going on. please help
  9. D

    Ebb and flow plant problems.

    On another note, I could always turn my ebb and flow into a drip to waste or drip to recirculate. Would that be better than fill and dump?
  10. D

    Ebb and flow plant problems.

    Yes humidity is low. I have a 5 ton air handler inside and it keeps sucking out all the moisture from the room. I have a small humidifier inside and sometimes I wet the concrete floor with water to create moisture. It been running at 35-45%. Not sure what else to do but getting a fogger? My...
  11. D

    Ebb and flow plant problems.

    Do I just add little more of flora nova into the res or do I need a complete water change out.
  12. D

    Ebb and flow plant problems.

    About 2 days I also added about 15 gallons of fresh water to res. Now I'm at 5.9 and 700 ppm after adjusting water
  13. D

    Ebb and flow plant problems.

    Ok just checked my ph today and it hit 6.5 from 5.7 the ppm stayed the same 800
  14. D

    Ebb and flow plant problems.

    I forgot I have this UC roots. I used it in deep water culture that my friend Gabe me but that was too hard to maintain a current culture system. This uc roots is used to keep the water sterilized. On back it says it's used for ebb and flow too. Let me know what you think of this product. It's...
  15. D

    Ebb and flow plant problems.

    Got it. I will flush using just ph water cal mag and epson salt. Thank you.
Top