Recent content by dinkydigger

I hope your not planning on using the aluminum foil for reflective purposes

Since you have sliding doors, you could get a piece of that thick styrofoam insulation, open to how ever big you want, cut it to fit and then cut a hole so you can run a duct out. Don't know how stealthy you need it to look, but that should work for the heat problem.

Does it have a separate ballast with a hood, or is it like an outdoor light fixture?

Is it an actual 150w hps grow lamp?

Yeah. Maybe if you smoked 40 joints a day, I could see it causing problems.

Get some more lights. 2 125w clfs aren't much. You're probably not going to get much of a yield out of it. Dido on putting the lights closer as well. Besides that it looks pretty healthy.

If you go HPS, yes do the duct work. CFL I think you would be fine with just a fan. As far as the watering, usually once a week during veg and they tend to consume more during flowering, so sometimes twice a week, but best way to tell is stick your finger into the soil about 3/4 to an inch, if...

If you go CFL, you will want to put some lights on the sides of the plants in the middle( a couple clamp lights work well) so the light will penetrate the buds a bit better. I did a closet grow in a 3rd floor apt. with 4 42W in a homemade hood reflector and 2 23W on the sides and got a pretty...

the reflector looks like it wouldn't be that great....you can find something better...

yes, you can stress it to hermie....BUT....hermie seeds will usually produce more hermie plants.......

looks like mold...you can get a spray to get rid of it....could be mites too...but i'm guessing mold

i imagine you are using clones, are they from a different mother than the last time? i have found that after the first set of clones from the mother, they get weaker and weaker each time. after the first go around. what i have experienced, the yield was cut in half from the first time

heat or nute burn..pics would be helpful...also add some molasses to kick up the potassium(k). potassium is what controls the water flow through the plant and the more you have, the more it will distribute all the other nutrients evenly through the plant instead of just heading straight to the...

..orrrr...pay attention to detail and touch them and look at them..

do you have a dome over them?...they look like they are pretty much done for at this point...1000 watts is wayyyy too much..you need to get (as stated before) low watt 6500k cfls, regular flors or the t5 bulb...the purpose of the dome is to get the humidity up so the clone can take in moisture...