Recent content by dalack

Does anyone have any experience with this? https://monstergardens.com/the-microfog-low-pressure-carbon-fiber-atomizer-1-4-inlet-output.html

Thanks for the great info and quick reply. I'm using dwc right now and am having issues with root rot so I was recently looking into flood and drain. Looks much easier and less chance of root rot? How does growth and yields of flood and drain compare to dwc in your opinion? If close or equal...

I bought a AQUATEC CDP 8800 high flow booster pump to run a hpa setup. If a hpa only runs every 5 minutes for 5 seconds why is a accumulator recommended? That doesn't seem like it would be taxing for this pump. The pump is only a hundred bucks and if I can get a grow out of one it would be...

Just ordered a 16 oz bottle of Southern AG Garden Friendly Fugicide and I'll report if it works. I also raised the level of the water half way up the pots and the plants seem to be doing better and the roots look better already. I'm thinking the roots might of been dying because they were...

Having a problem with my rdwc grow. Had a problem with root rot. The plants started to recover with new lateral root growth out of the side of the pots. Thing is the roots will start to brown, especially the ones that are not submerged under the water. Is it OK to bring the water level up so...

Has anyone used this power supply to power the bridgelux strips? LRS-350-36 https://power.sager.com/lrs-350-36-4051787.html?utm_source=googlemerchant&utm_medium=click&utm_campaign=power-brand&gclid=Cj0KCQiAn8nuBRCzARIsAJcdIfMFlvPFhi9W08dwSjcHEwqPnUl6NyAE5BgLOrxk4toIoF2N3x5rdw0aAuzCEALw_wcB At...

I found this motorized 6" vent for intake air. https://www.supplyhouse.com/Broan-MD6TU-6-Automatic-Make-Up-Air-Damper-w-Pressure-Sensor-Kit-Direct-Wired?gclid=Cj0KCQiAtrnuBRDXARIsABiN-7DT6707jZxt6f4AtGasU5Kjc--6Ib0kh6myT-TW6lFBjWso8S5TdsgaAtY-EALw_wcB Do you think 6" will be a sufficient...

Thanks for the reply. Do you know how much I'll gain by using 3rd gen instead at that current? Thanks again David

Thanks What do you think about running vented 1k watt fixtures without the glass? You think that would pull out enough heat and pull in enough makeup air? Since you have alot of experience with hps what do you recommend for de 1000 fixtures? Are gavitas the only way to go or will I get decent...

Thanks for your advice. Do you know how much heat cobs put out compared to hps? In the summer I might switch over to leds

It was recently sprayed with closed cell foam so its extremely tight. So you don't think sealing the room and using c02 for veg and flowering would be more efficient? Now that I think about it I'm probably using the mini split to heat if I'm using the leds or using the heat of the hps lights so...

Hi everyone I have a 9x9 shed setup and live in the northeast where temps range from 15-55 degrees in the winter. I'm trying to figure out a venting solution to keep the room at an adequate temps and not have a fan pulling my heat out and cold air in. Right now I have a 9k mini split to heat...

Does anyone know if I can run these strips without heatsinks? I Bridgelux Gen. 2 BXEB-L1120Z 4′ LED Strip Build – 5’x5′ Parts list: 18x BXEB-L1120Z 4′ Strips ($253) 1x Mean Well HLG-480H-42B Driver ($115) 1x Mean Well HLG-240H-42B Driver ($64) 1x 50K Ohm Potentiometer for Dimming ($7)...

https://www.alibaba.com/product-detail/2019-Nalite-new-model-direct-sell_62216717326.html?spm=a2700.12243863.0.0.427c3e5fHlIT1s Its $700 shipped. They say there won't be tariffs on it but we'll see. I actually have a 9x9 space so was thinking four of these 800 watt lights. I can always dim them...

So what should I be looking at besides ppfd in regards to this light?