not much new to report other than I'm planning on running duct to the light tomorrow, I have the whole day to myself so I'll probably get bored and do some more stuff to improve my grow.
btw, one of my plants is Huge and already out growing my grow room nearly touching the light. It's rather limber and has shit tons of branches on it. Would there be any way to bend it in half without breaking it? and would it harm production to do it during the flower period? help and other ideas are welcome
End of day 8 pics,
Last night the temp somehow dropped to 58 last night, I didn't check it until about 3, so it was like that for about 4 hours I figure. I turned the ac down to 72f and the lights just went off at 7 anyways so the AC will be off in about a half hour (to get rid of residual heat from the light). 3-4 of my plants are slouching slightly, there is no curling of the leaves or visible trauma so I think they'll be fine after a good rest
End Of Day 10 under 12/12
I did some rearranging of my tent and ended up putting scrog 2 directly underneath the light (18" from tops of plants ) I would like to lower it more but I dont want to take away from the other plants either by cutting into the light distribution.
Also, I bent and tied back about 5 of the plants including my huge mutant that we call "Lumber Jill" that's actually about 8" taller than any of my others.
Nice buds forming all over.
Day 13 of flower; Happy 4 20 everybody!
The ladies are continuing to flower nicely and are still stretching more and more. I think I'll try an indica for my next scrog and just 2 plants.
Sorry about this one, my camera has issues when the light is on, I was trying to do a close up of one of the tiny nugs that's starting to form
....... and pay no mind to the temp, it just goes up a bit when I have the tent open to do work, my temps have been slightly higher but still below 75f