you could try putting them on one end and tilt the lighting. I would definitely give those clones a neem oil bath then a rinse the next day before putting them in there.

__________________

Waterfarm (completed) Cabinet to Waterfarm (completed) Nute Challange (completed)

LED/T5/400W Cabinet (completed) Dual Cabinet Build (current) Dual Cabinet Grow (current)

Meh, you kind of freaked me out. I think I'm gonna just pot them with some medium and put them somewhere else and just water them. Probably take clones for the next round if they end up looking better.

Blah shit. If they've been in there for a day is it possible that mites have already... transferred... or whatever. To other plants? Shit.

One Day, Probably not. once they get established they look for new leaf.

__________________

Waterfarm (completed) Cabinet to Waterfarm (completed) Nute Challange (completed)

LED/T5/400W Cabinet (completed) Dual Cabinet Build (current) Dual Cabinet Grow (current)

Cool, well they're out now. I'll either give them back or see how they do somewhere else. Maybe give them a small flouro somewhere if I can afford it. I'm guessing in the end they probably won't make it, which is sad, but better them than the all of the little seedlings just coming into the world. :-p

Nothing much new under the sun. Well, fake sun. :-p

Day 9. I think?:

Attached Images

	IMG_0089.jpg (80.2 KB, 19 views)
	IMG_0093.jpg (67.0 KB, 14 views)
	IMG_0091.jpg (64.9 KB, 15 views)
	IMG_0090.jpg (84.2 KB, 16 views)

Is it alright that my humidity goes down during the day when I have a fan on inside to keep the heat down, as long as it goes back up at night when the lights are off? I'm around 20% during the day and 50-60% at night.

Good job man, they are all looking healthy.

I have found humidity is real important the first week but after that not so important.
20% is low but OK. You could try trays of water, or a wet towel, to add humidity in a small area, just let them evaporate.

__________________

Waterfarm (completed) Cabinet to Waterfarm (completed) Nute Challange (completed)

LED/T5/400W Cabinet (completed) Dual Cabinet Build (current) Dual Cabinet Grow (current)

Yeah, I would have thought that it'd be much higher given that I'm doing the whole aeroponics spray thing.

These are day 12:

Attached Images

	IMG_0096.jpg (83.8 KB, 12 views)
	IMG_0097.jpg (80.1 KB, 7 views)
	IMG_0098.jpg (62.3 KB, 8 views)
	IMG_0099.jpg (72.2 KB, 10 views)

There a bit of burn on one of them in the above post, I think it's just because some water got stuck on the tip of the leaf, but can't be sure. The other is kind of dirty/burned and I think that, again, it's water getting up on the leaves, and there's a bit of nutrients in there now so... If anyone sees something different please let me know.

Day 13:

Attached Images

	IMG_0100.jpg (78.1 KB, 5 views)
	IMG_0101.jpg (88.3 KB, 7 views)

Well I think for the most part they look fine.
Water burn on the leaf usually is not on the tip. I think thats to much nutrients.

I wouldn't take them over 300 PPM at this point.
If you don't have a PPM meter then cut whatever the manufacture says in half.

Once they had a full set of three pointers then increase the strength of the nutes but to tell you the truth I run half strength just about the full grow. I boost in week 2 of flower thats about it.

What are you using?

__________________

Waterfarm (completed) Cabinet to Waterfarm (completed) Nute Challange (completed)

LED/T5/400W Cabinet (completed) Dual Cabinet Build (current) Dual Cabinet Grow (current)