Hi Everyone im back bigger and better than my 1st grow which is in my sig if any of you missed it, but after 4 months and loads of learning I ended up with about 300g’s of some Class 1 skunk so now ive decided to go bigger, and if any of you have looked because of the title of the thread, I am basing it on Al B Fuct’s perpetual harvest, except that I am sticking it all in budbox’s…….anyways here’s the equipment-some still to get…….

Mother Veg Room/Clone Room

XXL Budbox
1 Flood and drain table kit (90cm x 90cm)
1 x 600w MH Bulb in cooltube for mothers
1 x X-stream 36 site aeroponic propagator
1 x 125w envirolite for clones
Light Curtain to block HID light
1 x 8” Extractor fan (centrifugal)
1 x 6” Intake Fan (centrifugal)

Flowering Room

‘Titan’ Budbox (200cm x 200cm x 200cm)
4 Flood and Drain tables
4 x 600w HPS all in cooltubes
1 x 8” Extractor fan with odoursock
1 x 6” Intake fan
1 x 6” Centrifugal fan blowing al cooltubes venting outside the budbox airmass

Ok so as you can see it is pretty much setup the same as Al. B Fuct except im using grow tents, I know there has been a lot of criticism of Budbox’s but I have had very good results with them, it also helps a bit against the supposed ‘FLIR’ infra-red because it leaves airspace between walls and the budbox, therefore no hot spots on the exterior walls…..

Anyways back to my grow…so I brought 5 x Great White Shark (GHS) and 5 x Lemon Skunk (GHS) and then 3 weeks later I brought 5 x Super Lemon Haze (GHS) so I have 15 mothers in the veg room, the GWS and Lemon are ready to take clones but the Lemon Haze wont be ready for about 2-3 weeks….so all in all they are about 6 weeks old except the L Hazes’s which are bout 3……

I am setting up to take clones tomorrow, I am gonna take 30 and stick them in the aerocloner with only ph’d water until I see some root growth then I will be adding a bit of Canna Rhizotonic cos ive seen some amazing results with it in aerocloners, I will be repeating this process every 2 weeks using about 24/30 for flowering hopefully 1 oz baby’s in SoG…..so basically with the 4 tables and an 8 week flowering time I will be harvesting every 2 weeks….although ive never cloned so im expecting some teething problems….the remaining clones may be raised as mothers or discarded…..

I still have some equipment to buy as I only have 1 flood table for the Flower room ordered with the light etc but it will all be coming I just haven’t got round to order it yet….

My Mothers are vegging with an 18/6 light cycle, with weak nutes (1.0ec) as I have the baby lemon haze’s in there but I will be upping this weekend as they are ready for it, also it may account for the GWS’s being a bit smaller than the lemon skunk plants, as you can clearly see from the pics below that the lemon is a lot bigger and greener/broader leafed….

I only use Canna Nutes Aqua Vega + Flores and also PK 13/14 in week 5 of flower, ive had good results with them and I also have got the feeding pretty good so far so why change it…..

Anyways have a look at my pics and feel free to comment, I need some advice about cloning in the aerocloner as ive never done it if anyone can help, anyways let me know….

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

THE FLOWERING ROOM........

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

Ok so hi again all, just a quick update because i took some cones today......

Ok Basically i took 30 clones about 5" tall and put them in the aerocloner, i labelled each clone to know what plant it was from, so i can discard any rubbish plants.....

Ok so here's what i done....

1) Steriise everything
2) I cut a clone from the plant
3) I cut at a 45degree angle and scraped a bit of the 'skin' off
4) I cut about 1cm up the bottom of the clone
5) I dipped in clonex cloning geland then placed in neoprene collars/net pots

Ok so i filled my Aerocloner Res with nothing but ph'd water - 5.8 - ive heard that any nutes at this stage can actually slow things down, but as soon as i see some root growth i will add some nutes.....

My res temp was a bit cool cos i got the water from the tap, however within the next couple of hours it should warm to ambient temperature which should be ok for the clones.....

I have my lid on my aerocloner but i have my vents open, does anyone have any advice on this......????

I have my aerocloner set to 15mins on and the 15 mins off, even during the night as its on a 18/6 lighting schedule......does this sound ok....???

This is my 1st time cloning so im expecting it not to work lol but if it does then maybe i have a green thumb, i dunno what else i coud adjust to make cloning conditions better.....

Anyways heres some pics, could anyone give me there opinion it would be very helpful,,,,,,thanks

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

I'm along for the ride! Looks nice

__________________
http://www.rollitup.org/grow-room-de...struction.html

Ok quick update all about the clones....

I took them on friday about 5pm o theyve been inthe aerocloner for about 48 hours now.....

At 1st the clones all drooped but after a few hours they all perked up. 1 of the GWS clones looked like it was dead but i eft it and that also has perked up so its all looking good.

Im really hoping some roots tart showing this week and as soon as some do ill add a mall dose of Canna Rhizotonic in there to boost the roots for a couple of days......

Anyways heres some pics just taken of the clones.....no yellowing they look very healthy.....











Lemme know what you guys think, thanks all

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

What does everyone think,do my clone look ok??? Does it look like they mite root or have i done something wrong, id appreciate some feedback if possible or anyone who wants to help, thanks again..........

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

I think you got everything under control. Good job!

__________________
http://www.rollitup.org/grow-room-de...struction.html

Subscribed

__________________
Current Journal, 1200w Alaskan Ice, Cheese, Trainwreck

Thanks for the comments all.....

Just a quick update...Day 4 - Still No Roots

I thought id change the water in the res because it was very hot and i thought it could only be good, when i put the new ater in i added 15ml of formulex-u can see the bottle in the pics-hopefully this might help them root soon.....

Ive also been doing a lot of reading and ive changed my timer for the aerocloner to 15 mins on and then 30 off, all day long......apparently the clones like a bit extra to dry out and use the oxygen so we'll see im still experimenting with a lot of this........

Here are some pics, it might be my eye sight but i could sear they look a bit bigger in these pics than they did for the last pics, does anyone agree??????

Pics









Lemme know ur opinions guys i really need advice on the clones as ive never done it before, do they look ok, do i just keep waiting?? Comment please thanks

__________________
My flood an drain white shark journal........now harvested!!!

My 4 Flood table 2 week harvest Super Lemon Haze

They look good to me, give them a few more days and you will see progress. What have the temp ranges been for the res?

__________________
Current Journal, 1200w Alaskan Ice, Cheese, Trainwreck